Avaya Bogen Easy Install Speaker User Manual
Easy Install
™
Speaker
Speaker Installation
Step 1
Step 2
Step 3
STEP 1 - Set speaker tap to correct setting using the chart below.
Position the speaker on the ceiling tile and slowly push the
speaker, forcing the studs through the ceiling tile.
STEP 2 - Clean any loose debris and foil (see note below) from
around the studs. Spin the wide-based wing nuts (supplied) down the stud. Tighten the wing nuts until they are
very snug (finger tighten only - no tools required). Check
that the speaker is drawn tight to the ceiling tile.Fiberglass
sleeves (supplied) should be placed over the studs at this
point to insulate the exposed portion of the stud as a
safety precaution.
IMPOR
TANT: When installing in ceiling tiles with foil back-
ing, it is very important to remove foil from around the studs
so that it cannot make contact with the stud. Foil that makes
contact with the studs can potentially cause a short circuit of
the amplifier output.
STEP 3 - The electrical connections are made to the studs with the
wire nuts (2 sizes are supplied. Use the ones that fit the
best for wire gauge used.). Note: Use 22 AWG shielded,
twisted pair (Com Code: 40
1
882956. Pec Code: 2734-SPK) on
all wire runs unless your layout recommends other wire to be
used. Connect speaker wire shield to the ground (GND)
terminal of the amplifier’s output. Carry the ground
through all speaker cables by tying the shields of the
speaker cables together in a “daisy chain” fashion.Do not
connect the shield to the speaker itself.The shield is
only connected at the amplifier end and simply floats.The
studs are color-coded to allow proper phasing.
Suggested amplifier connections are:
COPPER stud - 70V
NICKEL stud - COMMON
The speaker will also work perfectly well with these connections
reversed. However, it is important to be consistent in the wiring of
the speakers in the system. If adjacent speakers have reversed wiring
connections, they will tend to cancel each other’s bass response,
diminishing the sound quality.
Nylon wire ties (supplied) can be used to secure the speaker wires
to the studs if desired. (Nylon wire ties should wrap around the fiberglass sleeve.)
Issue 1, October 1999
54-2004-01 Printed in Korea 9910
© 1999 Bogen Communications Inc. All rights reserved.
Specifications subject to change without notice.
PEC Code: 5330-201
COM Code: 408185981
Model: LUEZIRCS
87
90
93
96
99
POWER SET
(WATTS)
0.25
0.5
1
2
4
dBspl
(@70V)
TAP SETTINGS
Easy Install™is a trademark of Bogen Communications, Inc.
Select Code:: 701-000-112
Loading...