Avaya Bogen 5W User Manual
Power
Supply
Telephone
White
Green
-24V DC
Audio Tip
Lead
Color
Function
Black
Red
Ground
(Positive)
Audio Ring
W iring Chart
5W Self-Amplified
Horn Loudspeaker
Description
Issue 1,October 1999
54-2002-01 Printed in USA 9910
© 1999 Bogen Communications Inc. All rights reserved.
Specifications subject to change without notice.
PEC Code: 5328-005
COM Code: 408186005
Model: LU5WSAH
Figure 1
Speaker Installation
This horn loudspeaker is a one-way,self-contained amplified paging horn assembly that incorporates a 5-watt amplifier with a
volume control.This horn may be used to expand the capability of telephone systems in high noise areas,and is suitable for
interior as well as exterior paging applications.
STEP 1 - For easier installation, remove the flange (base) from the speaker by
unscrewing the wing nut while at the same time pressing inwar dl y on the wing nut (see
Figure 1).Place the flange flush with the mounting surface and mark the location of the
three holes with either a marker or chisel.It is important that the three holes be exactly aligned with the flange,otherwise you might stress the base or make the connection
unsteady.Insert 3 wall anchors - see diagrams on back for drilling instructions and use
of anchors.(Use appropriate hardware for your specific mounting surface.)
STEP 2 - After mounting the flange, reattach the speaker to the flange and aim the
speaker for the desired coverage. A 45odownward angle is recommended, but this
may vary depending upon speaker layout. Unless otherwise indicated, do not aim
speakers directly at each other or poor paging intelligibility may occur.
STEP 3 - Remove the plastic cover to gain access to the volume control. Using the
table to the right and referring to Figure 2 below,make the electrical connection.The
red and green wires are dry loop 600-ohm inputs. Note: Use 22 AWG shielded,twisted
pair on all wire runs. COM Code: 401882956. PEC Code: 2734-SPK. Use a separate cable
for the power and signal connections. Connect the shield of the signal cable to the
ground of the audio source.Do not connect the shield to the speaker (the shield
is only connected at one end).
STEP 4 - Adjust the volume control to the desired setting. Replace the plastic protective cover back over the exposed area.
White
Black
24V DC
Power Supply
(use only terminals 1 & 2)
Self-Amplified
Horn Loudspeaker
Red
Green
Figure 2
Page 1 of 2
Using Anchors with Hollow Walls
Using Anchors with Solid Walls
Drill 5/16” diameter hole for each anchor and screw.
Fold and insert anchor in hole (see Figure 1).
Tap anchor until it is flush with the wall (see Figure 2).
Insert red key to pop anchor open behind wall (see Figure 3).DO NOTHAMMER KEY.
Remove key.
Place speaker flange (base) over anchors.
Insert screws and tighten until flush with the mounting surface.Do not over tighten.
Drill 5/16” diameter hole (minimum hole depth for solid walls is 1 1 /2”) for each anchor and screw.
Fold and insert anchor in hole (see Figure 1).
Tap anchor until it is flush with the wall (see Figure 2).
Place speaker flange (base) over anchors.
Insert screws and tighten until flush with the mounting surface.Do not over tighten.
red key
Page 2 of 2
Loading...