Avaya Bogen 35 User Manual

STEP ATTENUATION

10 0dB

9 -3dB
8 -6dB
7 -9dB
6-12dB
5-15dB
4-18dB
3-21dB
2 -27dB
1 -33dB
0 Speaker Off

(Full Volume)

Red

Black

Green

This 10-step plus “off ” speaker attenuator allows the volume of a network of 70-volt speakers to be controlled from a remote loca­tion.The attenuator can handle speaker loads of up to 35W (max.) and fits into a double gang electrical box. Volume reduction takes
place in 3dB increments except for the 2 lowest settings,which provide 6dB reduction increments.A speaker “off ” position is also
provided.

Speaker Installation

Attenuator Wiring

70-volt Hot

lead

70-volt COM

Cable Shields

Cable to speakers

Speaker “+”

positive lead

Cable from amp or zone output

Wire Nuts (4)

Note: Cable shield is not
connected to the speaker ­the shield simply “floats.”

Speaker “-”

(negative) lead

35W Attenuator

(for 70-volt speakers)

Speaker Load Maximum

35 Watts

Note: Use 22AWG shielded,
twisted pair on all wire runs.

COM CODE: 401882956

PEC CODE: 2734-SPK

Attenuator Settings

PEC Code: 5335-005
COM Code: 408187169
Model: LU35W70VAT

35-W att Attenuator For
70V Speaker Line

Figure 1

Page 1 of 2

Issue 1,October 1999
54-2005-01 Printed in Korea 9910
© 1999 Bogen Communications Inc. All rights reserved.
Specifications subject to change without notice.
Select Code:701-000-102

_

+

Attenuator Installation

1) Cut a rectangular hole 4-1/16” wide and 3-3/4”
high in the sheetrock where the attenuator is to be
mounted.

2) Pull approximately 12” of the amplifier and speaker
cables through the hole.

3) Push each of the separate cables through the elec­trical box entry holes and pull about 6” of cable
out of the front of the box (see Figure 2).

4) Rotate the two screw-mounted tabs down against
the box and slide the electrical box into the open­ing until it stops against the wall.

5) Begin to tighten both of the electrical box screws
until the box is held firmly into the wall.The clips
on the screws will rotate into place and clamp the
box against the wall.

6) Make all the necessary electrical connections as
shown in the “Attenuator Wiring” section on the
front of this sheet (see Figure 1).

7) Remove the protective plastic film covering from
the attenuator face plate.

8) Mount the attenuator to the electrical box using
the 4 screws provided. Using a Phillips head
screwdriver,screw the attenuator into place (see
Figure 3).

4 1/16"4 1/16"

3 3/4"3 3/4"

Figure 2

Figure 3

Screw-mounted tab

(down)

Rotated screw-

mounted tab

Entry holes

Page 2 of 2

22

33

11

VOLUMEVOLUME

44

00

55

66

77