Avaya 7430, 7440 User Guide

Nortel
Digital Mobility Handset 743X
and 744X User Guide

www.nortel.com
© 2008 Nortel Networks
N0000636 02
Printed in Denmark

Congratulations

on your new Nortel 743X/744X handset

X represents the frequency variant of
the models:

0 = (2.4 GHz frequency band)

4 = (1900 - 1930 MHz frequency band)

9 = (1920 -1930 MHz frequency band)

The handset 743X/744X will provide you with
the greatest possible degree of flexibility and
mobility due to high battery capacity, practi­cal weight, size and design.

6723

&KDUJH\RXU

KDQGVHW

KRXUVSULRUWR

ILUVWXVHIRUEHVW

SHUIRUPDQFH

Please note that the handset 743X/744X is
for use with the following Nortel host sys­tems:

• Norstar MICS 7.0 or greater (Modular
Integrated Communications System)

• Norstar CICS 7.0 or greater (Compact
Integrated Communications System)

• BCM1000/200/400 3.7 or greater
(Business Communication Manager)

• BCM50 Rel. 2.0 or greater
(Business Communication Manager)

• BCM450 Rel. 1.0 or greater
(Business Communication Manager)

Contents

Getting Started. . . . . . . . . . . . . . . . . . 7

Handset information . . . . . . . . . . . . . 7

Battery information . . . . . . . . . . . . . . 8

Installing battery . . . . . . . . . . . . . . . . 9

Charging battery . . . . . . . . . . . . . . .10

Checking battery capacity . . . . . . .11

Battery disposal . . . . . . . . . . . . . . . 12

About your 743X/744X handset . . . 13

Handset display . . . . . . . . . . . . . . . 15

Display softkeys . . . . . . . . . . . . . . . 17

Display backlight . . . . . . . . . . . . . .17

Basic handset options. . . . . . . . . . . 18

Turning the handset ON/OFF . . . . . 18

Adjusting speaker volume . . . . . . . 18

Changing Menu Language . . . . . . . 18

Customizing handset . . . . . . . . . . . 19

Making and answering calls . . . . . . 22

Dial directly . . . . . . . . . . . . . . . . . . .22

On hook dialling (pre-dial) . . . . . . . 22

Dial from your phone book . . . . . . .23

Redial . . . . . . . . . . . . . . . . . . . . . . . 23

Answering calls . . . . . . . . . . . . . . . 24

Hold a call . . . . . . . . . . . . . . . . . . . . 24

Making or answering a second call 25

Mute a call . . . . . . . . . . . . . . . . . . . 25

Turn on loudspeaker . . . . . . . . . . . 25

Replying to messages . . . . . . . . . . 26

More handset options . . . . . . . . . . . 27

Moving around in the Menu . . . . . . 27

Using phone book . . . . . . . . . . . . . 30

Using text messages (MSF) . . . . . . 34

Shortcuts . . . . . . . . . . . . . . . . . . . . 38

General information. . . . . . . . . . . . . 39

Troubleshooting . . . . . . . . . . . . . . . 39

Information . . . . . . . . . . . . . . . . . . . 39

5

6

Getting Started

Read all the information in this section
before you use your handset.

Handset information

Ensure that the adapter voltage is the
same as the electrical outlet voltage.
The 743X/744X handset uses radio
signals and does not guarantee a
connection in all circumstances. Do
not rely on a cordless handset to
make emergency calls.

Never use your handset:

• in the vicinity of electrical
detonators

• in shielded rooms

• in areas where radio transmission is
forbidden

• in aircraft

Do not place a handset near:

• water, moisture or damp areas

• heat sources, direct sunlight or
unventilated areas

• devices which generate strong
magnetic fields such as electrical
appliances, fluorescent lamps,
computers, radios, televisions or
fax machines

• areas where the handset can be
covered, its ventilation impaired,
liquid spilled on the unit or objects
inserted into the handset through
any openings.

7

• areas with dust, vibration, shock or
temperature extremes

Check for small metal objects in the
handset earpiece/mouthpiece before
using the handset.

Do not store or locate flammable liq­uids, gases, or explosive materials in
the same compartment or vicinity as
the cordless handset, its parts or
accessories.

Battery information

Read the following information before
you handle the batteries:

• Do not replace the batteries in
potentially explosive environments,
such as rooms where flammable
liquids or gases are present.

• The battery will explode if disposed
of in a fire.

• Do not charge the batteries unless
you use the Nortel Networks
approved charger and the proper
batteries.

• Only use battery type NT7B65LDE6 in
the 743X/744X handset. Do not
use these batteries with other
products. These batteries were
designed specifically for use with
the 743X/744X handset and the
743X/744X charger ONLY.
Improper use of the batteries may
result in fire hazard.

• Do not do anything that would
cause the battery to short circuit.

• Do not let the battery or the charger
come into contact with conductive
metal objects.

8

Installing battery

The battery is connected to the hand­set when it is shipped from the fac­tory.

1 To change the battery unscrew

the plate on the rear of the
handset to access the battery
compartment. Use a normal
screw driver.

2 Insert the screwdriver into the

small crack behind the blind cover
and break to open the handset.

3 Place the battery plug in the slot

in the battery box.

4 Insert battery with the label

readable.

5 Replace the back cover.

9

Charging battery

When charging the battery for the first
time, it is necessary to leave the
handset in the charger for 14-16
hours for the battery to be fully
charged.

During normal operation, it takes
approximately 3.5 hours to charge the
handset from fully discharged to its
full capacity.

• Place the handset in the charger.

For correct charging, be sure the
room temperature is between 0°C
and 25°C. Do not place the
handset in direct sunlight. The
battery has a built-in heat sensor
which will stop charging if the
battery temperature is too high.

10

If the handset is turned off when
placed in charger, only the LED
indicates the charging. When
handset is turned off, the LED
flashes at a low frequency while
charging and lights constantly
when the charging is finished.
There will be no reaction for
incoming calls.

If the handset is turned on when
charging, the display shows the
charging status. The display goes
back to normal mode when fully
charged. It will not vibrate.
Auto-answer is inactive. The
handset reacts normally for
incoming calls.

It is necessary to recharge the battery
when the display shows BATTERY
LOW, or if the handset cannot be
turned on. When the battery is fully
discharged, up to 10 minutes may
pass before charging begins (display
lights up). When the charger begins
the charging, status is shown in the
display if the handset is turned on.

Checking battery capacity

In the BATTERY MENU it is possible
to see the remaining battery capacity.

For reading the correct capacity, the
handset has to be removed from the
charger for at least one hour.

1 Press MENU ( ) and use the <

or > keys to reach the BATTERY

MENU.

2 Press 3 to enter the BATTERY

MENU, and see the current status

of the battery capacity.

11

3 Press 3 to return to the menu

system, or press MENU ( ) to
quit.

The indication on the display is not
necessarily an exact reflection on the
remaining speech time, but only an
indication of the voltage on the bat­tery.

Battery disposal

Defective batteries must be returned
to a collection point for chemical
waste disposal.

Warning: Nickel metal hydride

batteries must be disposed of
properly. Do not dispose of the
batteries in office or household waste.

Nickel metal hydride batteries are
recyclable. You can help preserve the
environment by returning your
unwanted batteries to your nearest
recycling center for recycling or
proper disposal.

Contact your system administrator for
more information about battery dis­posal and recycling centers in your
local area.

12

About your 743X/744X
handset

A

C

C

D

D

J

J

J

F

H

G

H

K

E

Message indicator light

A

Flashes when you have a
message waiting.

Volume control

B

Adjusts the handset and ringer
volume.

Display

C

Shows call information, handset
status icons, and guides you
through features and option
menus.

Headset connector

D

Only available on handset 744X.

B

I

L

13

Microphone

E

Keys F to L activate different
functions when your handset is
on hook or off hook.
On hook: Handset is idle (not in
use).
Off hook: Handset is active, call
or feature in progress.

Menu key

F

On hook
(idle)

Off hook
(active)

G

On hook
(idle)

Off hook
(active)

H

On hook
(idle)

Off hook
(active)

I

On hook
(idle)

Off hook
(active)

J

On hook
(idle)

Enters the Handset
Options menu.

Activates a feature option.

< ( ) key

Enters the Redial List
menu.

Activates a feature option.

> ( ) key

Enters the Telephone
Book menu.

Activates a feature option.

3 ( ) key

Turns the handset off with
a long (four second) key
press.

Turns the microphone off
or on when you are on a
call.

Feature key

Turns the display on for
three seconds with two
rapid key presses.

OR

Starts a feature session.

14

Off hook
(active)

Starts or ends a feature
session.

OR

Turns the loud speaker on
with a long key press
(only available on handset
744X).

R ( ) key

K

On hook
(idle)

Opens your message list
with a short key press.

OR

Enters the text message
(MSF-MAIL) menu with a
long (three second) key
press.

Off hook

Places calls on hold.

(active)

L

On hook

On/Off hook key

Turns the handset on.

(idle)

Off hook

Ends an active call.

(active)

Handset display

There are four lines on your handset
display.

Display information example

61-:   !

<1@1>OMXXQP

:1D@ /-88 1>-?1

(((.)))

Line 1

Line 2

Line 3

Line 4

15

The types of information shown on
the display are:

• Standby text: When the handset
is on hook (idle), your extension
name and number appears on the
first line of the display.

• Information text: Call or feature
information appears on the second
line of the display.

• Feature options: Feature options
appear on the third line of the
display.
Feature options vary, depending on
the type of call or feature in use.

• Handset icons: The following
icons appear on the fourth line of
the display:

The radio signal icon indicates

((.)))

connection to system.
Note: The icon flashes when
the system is busy and you
will not be able to make or
answer calls.

The envelope icon indicates a
new text message
(MSF-MAIL).

Left and right arrow icons
appear on the display when
you access Handset option
menus.

The telephone icon indicates a
call is active.
Note: The icon flashes when a
call connection is in progress.

16