Autostart AS2501 Users Manual

AUTOMATIC TRANSMISSION REMOTE STARTER
AS-1735SH
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle is parked in a safe and responsible manner.
1. When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in “Park” in order to avoid accidents upon remote starting.
2. It is the user's responsibility to ensure that the remote starter is disabled or put into valet mode before servicing.
WARNING
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
DOC:.1.00 – July 31, 2006 DL Lp Manufactured in Canada by Autostart
Table of Contents
Transmitter Part Number and Serial Number of the Remote Car Starter
Module ................................................... 2
Introduction........................................... 2
Using the Remote Control ................... 3
Vehicle Presets ..................................... 3
Heater & Heated Seat......................... 3
Windshield Wipers & Radio &
Headlights........................................... 3
Arming the Starter Kill.......................... 3
Remote-Starting Your Vehicle............. 4
Remote-starting .................................. 4
Driving Off........................................... 4
Remote Starter Features...................... 4
Idle Mode............................................ 4
Valet Mode.......................................... 4
Valet Mode Using the Valet Switch
.................................................... 4
Ignition Valet ............................... 5
Remote Valet Mode .................... 5
Panic Mode......................................... 5
Quick LockoutTM.................................. 6
Cold Weather Mode............................ 6
Transmitter Part Number and Serial Number of the Remote Car Starter Module
The boxes below contain information concerning your transmitter and Remote Car Starter. We entered the part number of your transmitter for you. Should you need to order a new transmitter, you will need to provide the transmitter part number which is printed below. The second box contains the serial number of the Remote Car Starter. Please make sure that the installer has entered the serial number in that box.
Extended Run Time ............................ 6
Advanced Features: Installation-
programmable Options ........................ 6
Active or Passive Arming................ 6
Remote Door Locks........................ 7
Priority Door Access .......................7
Ignition-controlled Door Locks ........7
Ignition Re-lock ............................... 7
Secure Lock.................................... 7
Remote Trunk Release................... 7
The Starter Kill and the Anti-grind
Feature ........................................... 7
Safe Start........................................ 7
“Home ValetTM” Mode .....................7
Turbo Mode .................................... 8
Engine Run Time ............................ 8
Flashing LED ..................................8
Horn Chirp Timing............................... 8
Multi-car Operation ............................. 8
Troubleshooting Poor Transmitting
Range..................................................... 9
LIMITED LIFETIME WARRANTY........ 10
Transmitter Part Number: ASRA-2501G-100
The installer must use the space below to write the serial number of the Remote Car Starter and the location of the valet switch (if installed):
Serial Number of the Remote Car Starter:
Location of the Valet Switch (if installed):
Introduction
This is a state-of-the-art remote car starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features) and the Safe Start children safety feature. With many an advanced function, this product will satisfy any one your expectations from high-end commodity and security systems, without neglecting any standard feature commonly offered by entry-level starters.
AS-6104 SH/SR User Guide P. 2
Using the Remote Control
Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section, later in this Guide, for second-car transmitter functions).
The functions of the transmitter are as follows:
Pressing the LOCK and UNLOCK buttons simultaneously will activate the AUX 2 output.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if equipped) should not be left on instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become energized while running under remote start. When leaving the vehicle you must ensure that the windshield wiper and headlight switches are of vehicles could cause them to remain battery.
Arming the Starter Kill
The Starter Kill (if installed) can be configured by the installer so as to arm automatically (Passive Mode) or not to arm automatically (Active Mode). See section Passive or active arming, later in this guide, for more details on Passive Mode and Active Mode.
To disarm the Starter Kill, press the UNLOCK button on the transmitter. The parking lights will flash twice. If remote door locks are installed, this will also unlock the doors.
To arm the Starter Kill, press the LOCK button on the transmitter. The parking lights will flash once. If remote door locks are installed, this will also lock the doors.
In Passive Mode, the Starter Kill will automatically arm if the ignition key is not inserted Into the ignition switch within 1 or 3 minutes after unlocking (the key sense feature must be installed).
HIGH. It is recommended to leave the settings on LOW or MEDIUM
OFF. Leaving the headlight switch ON on certain types
ON even after remote starter shut down, resulting in a dead
AS-1725 SH Guide d’installation P. 3
Loading...
+ 7 hidden pages