Autostart AS-1565 User Manual

LIMITED LIFETIME WARRANTY
REMOTE STARTERS:
As the manufacturer, Autostart Inc. warrants to the original consumer purchaser only (NON TRANSFERABLE), that the remote starter module (control box) shall be free from defects in material and workmanship, for as long as the original consumer purchaser continuously owns the vehicle the remote starter was originally installed in, as specified below:
2) For the second year after date of manufacture, as specified by the serial number on the module, Autostart will replace the remote starter module free of charge with a repaired or refurbished remote starter module.
3) For the third and any consecutive years after the date of manufacture, as specified by the serial number on the module, Autostart will provide to the original consumer purchaser a repaired or refurbished remote starter module, for a repair charge of $35.00.
In all cases, the consumer must return the remote starter module to the point of purchase, and must provide an original proof of purchase to said retailer. A remote starter module will be returned to the retailer for the consumer to claim within a 4 (four)-week period. For case 3), a check in the amount of $35.00 must accompany the remote starter module, or the retailer may refuse the return.
ACCESSORIES:
Autostart Inc. warrants to the original consumer purchaser that it will replace any Autostart accessory part for a one-year period from date of purchase. Accessories include all items that are not remote starter modules (such as transmitters, sirens, LED, switch, etc.). Accessories will only be replaced if proven defective in materials or workmanship, and if, when returned to point of purchase, the retailer is provided with an original proof of purchase. The accessory will be returned to the retailer for the consumer to claim within a 4 (four)-week period.
WARRANTY IS VOID IF:
1) The product has been damaged, altered in any way, or tampered with, without
the explicit written consent of an Autostart technician. For remote starter modules, this includes the opening or removal of the module’s plastic covering, or the removal or alteration of the barcode label on the module’s plastic covering.
2) The product is damaged due to accident, fire, flood, shipping and handling,
misuse, neglect, or other conditions beyond the control of Autostart.
3) The product has been installed or repaired by anyone other than an authorized
technician.
4) The product has been improperly installed or used.
WARRANTY DOES NOT COVER:
1) Batteries.
2) Scratched or worn transmitter cases.
3) Installation and/or removal charges for all remote starter modules and
accessories.
4) Shipping and handling charges incurred for product exchange or replacement.
5) Any material damages other than to the product itself.
THIS LIMITED LIFETIME WARRANTY SHALL CONSTITUTE THE SOLE LIABILITY OF AUTOSTART INC. FOR OUR PRODUCTS, AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. THERE ARE NO WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. NO PERSON, FIRM OR CORPORATION IS AUTHORIZED TO ASSUME FOR AUTOSTART INC. ANY OTHER LIABILITY WITH RESPECT TO THE SALE OR USE OF OUR PRODUCTS. AUTOSTART’S LIABILITY, WHETHER BASED ON CONTRACT, TORT, WARRANTY, STRICT LIABILITY, OR ANY OTHER THEORY, SHALL NOT EXCEED THE PRICE OF THE INDIVIDUAL UNIT WHOSE DEFECT FOR DAMAGE IS THE BASIS OF THE CLAIM. UNDER NO CIRCUMSTANCE WILL AUTOSTART INC., ITS DISTRIBUTORS, OR THEIR AGENTS BEAR ANY LIABILITY WHATSOEVER FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
4
AS-1565 USER GUIDE
BASIC REMOTE OPERATIONS
Your AS-1565 is equipped with a 5-button remote transmitter.
The functions of the transmitter are as follows:
LOCK
STOP
TRUNK
START
UNLOCK
REMOTE STARTING YOUR VEHICLE
To remote start your vehicle, ensure that the system is NOT in Valet Mode (If the system is in Valet Mode, the LED will be ON), and then press the START button on
your remote transmitter for approx. 1 sec. The parking lights will come ON, indicating that the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking lights will stay ON during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut OFF, wait a few seconds, and try to start the engine again. It will try to start the engine the amount of programmed times (2, 3, or 4) before giving up.
DRIVING OFF
With the vehicle running under remote control, enter the vehicle and turn the key to the ignition ON position (Do not
turn the key to the START position with
the engine running. This will cause the starter motor to re-engage) and press
the brakes. You are now ready to drive off.
Rev: 2.10 La –Dec.13,2001 Manufactured in Canada by AUTOSTART
1
TURBO MODE (OFF by default)
When this option is programmed, the unit will always keep the vehicle running for 60 sec after arming and locking the vehicle to complete ready-mode.
NOTE: The vehicle can be shut off by remote within the 60sec, if turbo idle
down is not required.
To activate TURBO MODE you must do the following:
1. With vehicle running and the doors closed, press LOCK UNLOCK or START button on the transmitter until the Parking lights flash 3 times then come on solid.
2. Remove the key and exit the vehicle.
3. Lock doors - Vehicle will stay running for 60sec.
VALET MODE
The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle needs to be serviced, or if you park it indoors, there is no danger of accidentally starting the engine by remote control.
To put the system into
Valet Mode, turn the key to the ignition ON position, and press and hold the Valet switch for approx. 3 seconds. The LED will turn ON, letting you know that it is now in
Valet Mode.
To take the system out of
Valet Mode, turn the key to the ignition ON position, and press and hold the Valet Switch for 3 seconds. The LED will turn OFF, letting you know that it is now out of
Valet Mode.
COLD WEATHER MODE
Your Autostart can be set in Cold Weather Mode. When programmed, it will start and run your engine every 2 hours for 4-minute intervals (gas engines) or 20-minute intervals (diesel engines), during a period of 24 hours.
To program
Cold Weather Mode, press and hold the STOP button for approx. 5 seconds until the parking lights flash 3 times. To exit
Cold Weather Mode, do any of the following:
Open the hood
Start the vehicle by remote
Turn the ignition ON
Press and hold the STOP button for approximately 5 seconds.
NOTE: By pressing the brake, parking lights will flash once to let you know that your are in Cold Weather Mode. You must program Cold Weather Mode each time you want to use it.
2 7
PARKING LIGHT DIAGNOSTIC
FLASHES RATE DESCRIPTION
2 Slow
System power up
1- Doors locked by remote
1
Quick
2- Cancellation of cold weather mode 3- System shut down after expiration of run time
2
3
4
5
8
10
ON
Quick
Quick
Quick
Quick
Quick
Quick
20 sec.
Doors unlocked by remote
System is placed into cold weather mode
12-volts is detected on brake line while
running by remote
1- New transmitter code learn 2- Confirmation of tach learn
Confirmation of module being reset
Ground detected on hood-switch line while
remote started or running by remote
Hood switch was pressed 2 times within 4
seconds
Loading...
+ 2 hidden pages