Autostart AS-1452 HF, AS-1451HF User Manual

AUTOMATIC/MANUAL TRANSMISSION REMOTE STARTER SYSTEM

AS-1451HF/AS-1452 HF

User Guide

FCC USER NOTICE (U.S.A.):

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's authority to
operate the equipment.

It is the responsibility of the vehicle operator to ensure their
vehicle is parked in a safe and responsible manner.

1. a) Manual transmission

the user’s responsibility to ensure that the gearshift lever is
in the NEUTRAL position and the parking brake is engaged
in order to avoid accidents upon remote starting.

b) Automatic transmission

user’s responsibility to ensure that the gearshift lever is in “Park” in
order to avoid accidents upon remote starting.

2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.

WARNING

: When leaving the vehicle, it is

: When leaving the vehicle, it is the

DOC.1.00 DL Lp November 17, 2006 Manufactured in Canada by Autostart

Table of Contents

Introduction .....................................................2

Basic Remote Operation ................................3

Vehicle Presets................................................ 3

Heater and Heated Seat ...............................3

Windshield Wipers, Radio and Headlights.... 3

Arming the Starter Kill .................................... 3

Remote-starting Your Vehicle........................ 4

Setting Your Vehicle Into Ready Mode ......... 4

Remaining In Ready Mode ...........................4

Remote-starting ............................................4

Driving Off.....................................................5

Remote starter features.................................. 5

Idle Mode ......................................................5

Valet Modes .................................................. 6

Panic Mode...................................................6

Introduction

This Module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Cold Weather Mode ......................................7

Advanced Features: Installation-programmable

Options .............................................................7

Remote Door Locks ......................................7

Priority Door Access......................................7

Ignition-controlled Door Locks Option...........7

Secure Lock Option.......................................8

Remote Trunk Release Option......................8

Starter Kill / Anti-Grind ..................................8

Engine Run Time ..........................................8

Multi-car Operation........................................8

Troubleshooting Poor Transmitting Range

Issues ...............................................................9

LIMITED LIFETIME WARRANTY...............................10

Please Note:

• The AS-1451HF system is equipped with one 4-button

multi-channel Transmitter.

• The AS-1452HF system is equipped with two 4-button

multi-channel Transmitters.

P. 2 User Guide

Basic Remote Operation

Your remote car starter can operate two independent vehicles equipped with an identical
remote car starter (see multi-car operation on page 8).

The functions of the transmitter are as follows:

Pressing the

LOCK and UNLOCK buttons simultaneously will activate the AUX 2 output.

For certain vehicles:

• Pressing and holding the LOCK button for more than 3 seconds will lock all doors and will

send a constant pulse as long as the

LOCK button is held down (maximum of 15 seconds).

This constant pulse can be configured to activate certain functionalities such as rolling up
the windows – Please refer to your installer to see if your vehicle is compatible with
this option.

• Pressing and holding the UNLOCK button for more than 3 seconds will unlock all doors and

will send a constant pulse as long as the UNLOCK button is held down (maximum of 15
seconds). This constant pulse can be configured to activate certain functionalities such as
rolling down the windows – Please refer to your installer to see if your vehicle is

compatible with this option.

Vehicle Presets

Heater and Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on

LOW or MEDIUM instead.

on

Windshield Wipers, Radio and Headlights

HIGH. It is recommended to leave the settings

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are

ON on certain types of vehicles could cause them to remain ON even after the remote

switch

OFF. Leaving the headlight

starter shuts down, resulting in a dead battery.

Arming the Starter Kill

If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm
automatically) or in Passive Mode (will arm automatically).

• To disarm the Starter Kill in Active or Passive Mode, press the UNLOCK button on the trans-
mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will

User Guide P. 3