Autostart AS-1412 User's Guide

AUTOMATIC TRANSMISSION MULTI-CHANNEL REMOTE STARTER SYSTEM

AS-1412

User Guide

Transmitter Part Number and Module Serial

Number..............................................................2

Introduction .......................................................2

Remote-starting Your Vehicle ...........................2

Vehicle Presets.............................................2

Driving Off.....................................................3

Idle Mode ......................................................3

Valet Mode ........................................................ 3

Ignition Valet .................................................3

Valet Mode Using the Valet Button...............4

Cold Weather Mode......................................4

Advanced Features ...........................................4

Installer-programmable Features......................5

Troubleshooting Poor Transmitting Range Issues

..........................................................................6

Please note:

Button , is for the LOCK/UNLOCK functions.
Button ,, is for the START/STOP functions.
Buttons , & ,, (together) is for the TRUNK release function.

The LED is NOT included in this model.
The valet button is optional.

Remote Door Locks ...................................... 4

Arming the Starter Kill................................... 4

Remote Door Locks Option ..........................5

Ignition-controlled Door Locks Option ..........5

Secure Lock Option ...................................... 5

Remote Trunk Release Option ..................... 5

Engine Run Time .......................................... 5

Starter Kill / Anti-Grind .................................. 5

H.3.10.S.3.20 DOC 1.01 September 2, 2003 CA Manufactured in Canada by Autostart

Transmitter Part Number and Module Serial Number

Transmitter Part Number:

AS4

The installer is to write in the boxes below the Module’s serial number and the location
of the Valet Switch (If the valet switch is installed).

Module Serial Number:

Your Valet Switch is located (if installed):

Introduction

This Module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Remote-starting Your Vehicle

Press the ,, button for approx. 1 second. The parking lights will come ON, informing you that
the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking
lights will remain

ON during the pre-programmed run time.

If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on

LOW or MEDIUM instead.

on

HIGH. It is recommended to leave the settings

Windshield Wipers, Radio and Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must

P. 2 User Guide AS-1412