Autec RLBHA00M User Manual
Original instructions
AIR SERIES
Part B:
Conformity and frequencies
(434 and 915MHz)
INDEX
1 Conformity ............................................................................................................. 2
1.1 Conformity of frequency band 433.050-434.790MHz ........................................ 2
1.2 Conformity of frequency band 915-928MHz ..................................................... 2
2 Frequencies ........................................................................................................... 3
2.1 Frequency band 433.050-434.790MHz ............................................................ 3
2.2 Frequency band 915-928MHz .......................................................................... 4
AUTEC LIAIRI10-02
2
Conformity
1 Conformity
1.1 Conformity of frequency band 433.050-434.790MHz
Each AIR series' radio remote control working in the frequency band 433.050-434.790MHz
complies with the (R&TTE) Directive 1999/5/EC and its essential requirements.
Each radio remote control is also in conformity with the harmonised standards provided in
the EC Declaration of Conformity.
You can nd the EC Declaration of Conformity on the website www.autecsafety.com, in the
product page of the relevant transmitting unit.
1.2 Conformity of frequency band 915-928MHz
Each AIR series' radio remote control working in the frequency band 915-928MHz complies
with the essential requirements of the following regulations:
- FCC (Federal Communication Commission) Part 15
- IC (Industry Canada) RSS-102
Unit FCC ID IC Number
A8 transmitting unit OQA-A08LA0AM 9061A-A08LA0AM
Receiving unit G
ACRS13-G
Receiving unit G
DCRS13
Receiving unit L
ACRS13-L
Receiving unit M
ACRM15
OQA-RGAGA00M 9061A-RGAGA00M
OQA-RGEBA00M 9061A-RGEBA00M
OQA-RLBHA00M 9061A-RLBHA00M
OQA-RMCEA00M 9061A-RMCEA00M
a b c
a b c
a b c
a b c
a. Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
b. This radio transmitter has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna
type indicated. Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.
Antenna type Antenna gain Antenna impedance
Autec stylus λ/4 <0dBi 50 Ohm
c. Autec allows you to use only the dedicated antenna supplied either with the remote control or
as original spare part. The use of any other type of antenna is prohibited and will invalidate the
guarantee.
LIAIRI10-02
AUTEC - Air series
Loading...