BOOM-CG
CabGrabber
TM
Accessory
BOOM ARM SET-UP INSTRUCTIONS
DESCRIPTION:
For use with the Audix CabGrabber
TM
or Cabgrabber-XL, the
BOOM-CG boom arm features a 12 inch adjustable steel
tube that enables the CabGrabber to handle front address
microphones and a wide variety of miking positions.
HOW TO INSTALL:
1. Attach the BOOM-CG onto
the threaded portion of the
CabGrabber
THERE ARE 3 VARIABLES WITH THE CABGRABBERTM THAT WILL ENABLE YOU TO POSITION ANY MIC ON ANY CABINET:
TM
or CabGrabber-XL.
6. Thread the mic clip or
shockmount onto the boom arm.
2. Manually tighten the rest of the
way at the knurled locking nut.
7. Position the mic into the clip or
shockmount.
3. Place the CabGrabberTM, with
the boom arm connected, onto
the guitar cabinet by hooking the
back on rst then the front. (see
CabGrabber
TM
instructions for
more detail)
8. Using the thumbscrew on the
boom arm, slide the boom in or
out to the desired position then
lock into place by tightening the
thumbscrew.
4. Position the CabGrabber
arm so that it is pointing straight
up (90 degrees ) and tighten at
the knurled nut (as shown). This
is the best position for leverage
and balance of the boom arm.
1. The CabGrabberTM can be placed on either side of the cabinet and at any height on the cabinet.
TM
2. The adjustable boom arm can telescope out to 12 inches, but generally works best with a shorter telescoping
distance (like the main photo at top of page).
3. The adjustment between the boom arm and the CabGrabberTM allows the arm to swing either further away
from the speaker or closer to the speaker. For longer mics with end address design, swing the arm away from
the speaker grill. For side address mics (like the CX112B shown in the photos above), swing the arm closer to
the speaker grill.
www.audixusa.com Call: 503-682-6933 Fax: 503-682-7114
Audix Corporation 9400 SW Barber Street, Wilsonville, OR 97070
Loading...