ADX10 FLP / ADX10 FL
adx10 fl/adx10 flp
ADX10 FL/FLP
OVERVIEW:
The ADX10FL P is characterized with a uniformly controlled cardioid polar
pattern, helping to isolate the area or section being miked from other
instruments or vocals on stage. With a smooth and accurate frequency
range of 50 Hz - 18 kHz, the ADX10FL P is lightweight, low prole and will
provide natural sound with exceptional transient response.
The ADX10FL P, specically for use with a ute, includes a clip that
attaches to the headstock of a ute, an 8’ cable terminating to a mini XLR-f
connector and a phantom power adapter (APS 911). Other model versions
are available as well, one of which is the ADX10 FL; for use with the Audix
RAD360 wireless system which includes a ute clip, 3’ attached cable
terminating to a mini-XLRf connector.
Manufactured to high standards and tight tolerances, the ADX10FL P
features a modular threaded capsule, machined brass body with matte
black nish, high quality shielded microphone cable and a variety of optional
accessories.
ADX10-FL SUPPLIED ACCESSORIES:
Flute clip (MC FLUTE)
External foam windscreen (WS10)
Carrying pouch (P1)
ADX10-FLP SUPPLIED ACCESSORIES:
Flute clip (MC FLUTE)
External foam windscreen (WS10)
Carrying pouch (P1)
Battery / Phantom power adapter with on off switch and bass roll-off.
Includes belt clip. (APS 911)
FLUTE CONDENSER MICROPHONE
INSTALLATION INSTRUCTIONS
THE AUDIX ADX10 FL FLUTE MIC SYSTEM
With the “crown piece” detached, slide the flute
clip over the end of the “head joint” (as illustrated
above) and secure the crown to the head joint.
FEATURES:
Small, lightweight, low profile
Natural, accurate sound reproduction
Easy to use and set up
Field replaceable capsule
Available for wireless and wired applications
APPLICATIONS:
Flute (Standard size)
OPTIONAL ACCESSORIES:
WS10S - Snap to fit external windscreen
MC10L - Metal clip with tension fit wire loop
APS 910* - Phantom power adapter
WS10S MC10L MC FLUTE APS 911 APS 910
SPECIFICATIONS:
ADX10 FL/ADX10 FLP
Transducer Type Pre-Polarized Condenser
Frequency Response 50 Hz - 18 kHz
Polar Pattern Cardioid
Output Impedance 250 Ohms balanced
Sensitivity 4.5 mV / Pa @ 1k
Equivalent Noise Level 25 dB (A weighted)
Signal to Noise Ratio 69 dB
Power Requirements 5 - 52 Volts phantom
Maximum SPL ≥120 dB
Cable/Connector Shielded 3’ terminating to
a miniature 3 pin
Female XLR connector
Polarity Positive pressure on
diaphragm produces
positive voltage on pin
2 relative to pin 3
Housing/Finish Brass /
Black E-Coat
Weight 110 g / 4 ounces
Length 25 mm / .98 inches
FREQUENCY / POLARS:
ARCHITECTS AND ENGINEERS SPECIFICATIONS:
The microphone shall be of the condenser type with a modular threaded capsule. The microphone
shall be available in a cardioid polar pattern and shall have a 3’ or 8’ cable (depending on model)
terminating in a mini-XLR female connector. The microphone shall have a sensitivity of 4.5 mV /Pa and
a nominal impedance of 800 ohms at 1 kHz. The microphone shall have a maximum SPL level of ≥120
dB and shall be machined out of brass with a length of 25 mm and a capsule diameter of 10 mm. The
microphone shall be the Audix ADX10 FL.
OPERATION AND MAINTENANCE:
The ADX10 FL is designed to plug directly into the bodypack of the RAD360 wireless system. To
use the ADX10 FL as a wired mic, the model that includes the phantom power supply (ADX10 FLP)
will be needed.
The ADX10 FL and ADX10 FLP are low impedance microphones and should be plugged into a
“mic level” input on your console, mixer or recording device. The ADX10 FLP requires phantom
power and will NOT operate without phantom power voltage (minimum of 9 - 48 Volts) which is
available on most professional mic preamps and mixing devices. If phantom power is not available
on your equipment, use the Audix APS 911, a supplied accessory with the ADX10 FLP model that
allows for battery operation. Avoid plugging or unplugging the microphone from a PA system unless
the channel is muted or the system volume is turned down. Failure to do so may result in a loud
“popping” noise which could seriously damage the speakers in the PA system.
USER TIPS:
With the “crown” of the ute detached, simply place the “O-ring” portion of the ADX10-FLP mic clip
at the end of the “head joint” and reattach the crown to the head joint.
The APS 911 phantom/battery power supply: The mini-XLRf connector at the end of the ADX10FL plugs directly into the mini-XLRm connector on the APS-911 power adapter. Next, plug a
standard XLR-XLR microphone cable to complete the connection from the APS-911 to the mixing
board. The APS 911 has the option to be used in phantom power mode or battery mode. If there is
no phantom power available on the mixing console or equipment being used to amplify your signal,
use the battery mode to power up the mic. If further reduction of bass frequencies or plosives is
needed, the APS 911 is equipped with a base roll-off lter.
***All specications subject to change without notice.
SERVICE AND WARRANTY:
This microphone is under warranty for a period of 3 years from
any and all manufacturing defects. Should your microphone
fail in any way, please contact the Audix Service department
at 503-682-6933. A Return Authorization number is required
before returning any products.
CARE AND MAINTENANCE:
The ADX10-FL & ADX10-FLP are manufactured to exacting specs with
roadworthy construction. However, the capsule is highly sensitive and should
be handled with care. Avoid extreme temperatures and be sure to store your
microphone in the pouch provided when not in use. Moisture of any kind can
adversely aect the sound and performance of your microphone.
AUDIX WARRANTY REGISTRATION FORM
Name:________________________________ Model:___________________
Company:_____________________________ Serial Number:_____________
Address:______________________________ Store:____________________
City:_________________________________ Store Location:_____________
Prov./State:___________ Zip:_____________ Purchase Date:_____________
Phone: ( )___________________________ Signature:_________________
Email:________________________________ Date:____________________
Please register your product online at www.audixusa.com or mail this form to:
Audix Microphones P.O. Box 4010 Wilsonville, OR 97070
DIMENSIONS (mm):
www.audixusa.com
Audix Corporation 9400 SW Barber St. Wilsonville, OR 97070
Please Check all that apply:
Male Female
Age: Occupation: Primary Instruments: Product to be used for:
18 or Under Musician Vocal Pro live sound
19-25 Producer Guitar / Bass Pro recording
26-35 Sound Eng. Drums Home recording
36-45 Radio/TV Keyboard Rehearsal
46-55 Production Brass Installation
55 + Other _______ Woodwinds School
Strings House of Worship
How did you hear about Audix? Other ___________ Other ___________
Magazine Ad Online Ad
On-line Store Friend Do you own other Audix Products? Yes No
Salesman Other __________ Model(s) ________________________________
Have you visited the Audix website? Yes No
503-682-6933 Fax: 503-682-7114
1.1
Loading...