Audio-Technica ATM610 User Manual

ATM610

8 kHz

Polar Pattern

SCALE IS 5 DECIBELS PER DIVISION

LEGEND

200 Hz

1 kHz 5 kHz

Frequency in Hertz

LEGEND

12" or more on axis

Frequency Response

Response in dB

HYPERCARDIOID DYNAMIC VOCAL MICROPHONE

• Tailored for extended-range, high-fidelity vocal reproduction

• Hypercardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source

• Durable performance for professional applications

• Special dual-wall floating construction reduces handling noise and assures consistent performance from mic to mic

• Hi-ENERGY

neodymium magnet for articulate vocal reproduction

• Multi-stage grille design offers excellent protection against plosives and sibilance without compromising high-frequency clarity

™

• Quiet-Flex

stand clamp provides silent, flexible microphone

positioning

• Corrosion-resistant contacts from gold-plated XLRM-type connector

• Rugged, all-metal design and construction for years of trouble-free use

Output from the microphone's XLRM-type connector is low impedance (Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is ground (shield). Output phase is “Pin 2 hot” – positive acoustic pressure produces positive voltage at Pin 2.

To avoid phase cancellation and poor sound, all mic cables must be wired consistently: Pin 1-to-Pin 1, etc. For a high-impedance (Hi-Z) mic input, connect a Lo-Z balanced cable to a Hi-Z matching transformer (A-T CP8201 or equal) at the equipment input.

When using the ATM610 in settings with a stage monitor speaker, the speaker should be located 135° off axis (45° off the rear of the microphone). This placement, in conjunction with the microphone's unif possibility of undesired audio f

eedbac

ypercardioid pickup pattern, will virtually eliminate the

m h

Take care to keep foreign particles from entering the windscreen. An accumulation of iron or steel filings on the diaphragm, and/or foreign material in the windscreen's mesh surface, can degrade

mance

perf

ATM610 SPECIFICATIONS

†

ELEMENT Dynamic

POLAR PATTERN Hypercardioid

FREQUENCY RESPONSE 40-16,000 Hz

OPEN CIRCUIT SENSITIVITY –55 dB (1.7 mV) re 1V at 1 Pa*

IMPEDANCE 300 ohms

WEIGHT 280 g (9.9 oz)

DIMENSIONS 177.0 mm (6.97") long,

48.0 mm (1.89") diameter

OUTPUT CONNECTOR Integral 3-pin XLRM-type

ACCESSORIES FURNISHED AT8470 Quiet-Flex™stand clamp

/8"-27 threaded stands;

for

/8"-27 to 3/8"-16 threaded adapter;

soft protective pouch

†In the interest of standards development, A.T.U.S. offers full details on its test

methods to other industr *1 Pascal = 10 dynes/cm Specifications are subject to change without notice.

y professionals on request.

= 10 microbars = 94 dB SPL

Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224

Audio-Technica Limited, Old Lane, Leeds LS11 8AG England

www.audio-technica.com