Page 1
Quickstart Guide
Premium Powered Speakers
Unpacking
Your speakers were carefully tested and inspected before packaging
and shipping. After unpacking please check for any damage. It is rare
that any damage occurs during shipping, but if this does happen
contact the shipping company immediately. We also recommend that
you keep the original carton and packing material.
Quick Setup - Wireless connection
Connect the speaker wire from the left (powered) speaker to the right
(passive) speaker.
Connect the power cable to the A5+ rear panel and plug the other
end into an AC power outlet.
Connect the antenna to the A5+ rear panel.
Turn on the power switch on the rear panel. The A5+ will go into
wireless pair mode and the Pair button on the rear panel of the
powered speaker should be ashing.
On your device, turn on Bluetooth and go to Bluetooth preferences.
Select "Audioengine 5+" to pair and connect. The Pair indicator on the
A5+ rear panel should stop ashing and turn solid.
Play your music and adjust volume levels on A5+ and your device.
Repeat steps 5 and 6 to add additional devices. A5+ can connect only
one device at a time, but it will remember up to six devices.
To disconnect from a paired device and put the speakers back into
pair mode, either remove the speakers from your device or press and
hold the Pair button on the rear panel until the indicator begins
ashing.
6
7
Safety Instructions
1. Please read these instructions before using this product.
2. Keep these instructions for future reference.
3. Heed all warnings on the product and in this guide.
4. Follow all instructions.
5. Do not use this apparatus near water or moisture.
6. Clean only with a dry cloth and as directed by the manufacturer.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
8. Do not install near any heat sources, such as radiators, heat registers, stoves or other
apparatus that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wider blade or third prong are provided for your
safety.
10. Protect the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Use only attachments or accessories specied by the manufacturer.
12. Use only with the cart, stand, tripod, bracket or table specied by the manufacturer or
sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of
time to prevent damage to this product.
14. Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way such as power supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
Welcome to the Audioengine family and congratulations on your purchase
of the Audioengine 5+ Wireless Powered Speaker System!
The Audioengine team is dedicated to bringing you the highest-quality
listening experience possible and the Audioengine 5+ Wireless speakers
were designed with the same attention to detail and operational simplicity
as all other Audioengine products.
As with our other past eorts, we want to thank our customers, distributors,
and resellers for the inspiration to create another great Audioengine
product.
What’s in the box
A5+ Wireless powered (left) speaker
A5+ Wireless passive (right) speaker
Remote control
Antenna
Speaker wire (16AWG), 3.75 meters (~12.3ft)
Detachable AC power cord
3.5mm mini-jack to mini-jack audio cable, 2 meters (~6.5ft)
RCA-to-RCA audio cable, 2 meters (~6.5ft)
Cloth speaker bags
Cloth cable bag
Setup guide
Product line brochure
Features
Built-in power ampliers
High-delity Bluetooth® with aptX® HD + extended range
RCA and mini-jack audio inputs
Remote control
Variable preamp audio output
Custom Kevlar woofers and silk tweeters
Hand-built MDF wood cabinets
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK.)
NO USER-SERVICABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION
ATTENTION: POUR RÉDUIRE LE RISQUE DE DÉCHARGE
ÉLECTIQUE, NE RETIREZ PAS LE COUVERCLE (OU
L’ARRIÈRE.) IL NE SE TROUVE ÀL’INTÉRIEURAUCUNE
PIÉCE POUVANT ÊTRE RÉPARÉE PAR L’USAGER.
S’ADRESSER ÀUN REÉPARATEUR COMÉTENT.
RISQUE DE CHOC ÉLECTRIQUE
NE PAS OUVRIR
AVIS
1
2
3
4
5
Wired connection
Connect one of the included audio cables to your music player
(phone, tablet, computer, TV, etc.) and the other end to an input on
the A5+ rear panel.
Play your music and adjust the volume on the speakers and your
device to the desired listening levels.
Inputs and volume settings
Multiple sources and devices may be connected to the speakers at
the same time and all inputs are open and active so it’s easy to
switch between your tablet, phone, TV, or any other device.
To adjust the volume, we recommend you rst set a level on the A5+
and then use the volume control directly on your device to adjust
the overall level. Volume settings are exible and there is no right or
wrong so feel free to experiment to nd settings that work for you.
Break-in Period
Your speakers will sound great out of the box and will get better
over time. No need to do anything else but listen to them. We do
recommend that you give them at least 40 to 50 hours break-in time
before doing any critical listening.
Cleaning
We don’t recommend using any solvents or cleaners. Just wipe down
the cabinets with a soft, dry cloth.
For additional setup instructions and troubleshooting tips, go to
http://support.audioengineusa.com.
1
2
Other Features
Variable audio output
The A5+ Wireless Powered Speakers include a variable full-range preamp
audio output so you can connect a subwoofer. You can also stream music
to other systems around your house by using our add-on wireless adapters. This output is variable (adjustable) so the volume level of the output
can be conveniently controlled from the A5+ front panel or remote
control.
Stand Mounting
Threaded ¼’ x 20 brass inserts are included on the bottom of each speaker
cabinet to provide the ability to attach the speakers to oor stands;
however, these inserts are not designed to support the full weight of the
speakers and therefore should not be used with single-point wall or ceiling
mounts.
Important safety note: It is the customer’s responsibility to check with the speaker stand
manufacturer to determine whether that specic stand is capable of handling the
weight and proportions of these speakers in safe and stable manner. The customer is
also responsible for proper selection of mounting hardware not included with the
speaker and for the proper assembly. Audioengine disclaims any liability for the
selection of suitable oor stands and/or correct hardware between the selected stand
and these speakers.
Speaker Placement
Although your A5+ speakers are very forgiving with regards to where you
place them, it’s true that proper speaker location can have an impact on
sound quality. Even though there seem to be dierent theories on correct
speaker placement, rooms and tastes are dierent so it’s dicult to
recommend a perfect setup. We do suggest you feel free to experiment to
see what works for you.
As a general rule of thumb for the best soundstage and imaging, the
speakers should be equidistant from side walls and a dierent distance
from rear walls. Tweeters should be at about eye-level in your most
frequent listening location and for the best bass response we recommend
at least 6 inches of clearance between the rear of the speakers and the wall
behind them.
Here are a few more suggestions, assuming you have some exibility
regarding where you place your speakers. No need for concern if your
situation and listening environment dictate the speakers’ position.
Both speakers should be equidistant from your primary listening position.
Placing the speakers at least 6 feet (1.8m) apart usually provides the best
imaging.
Try to keep the speakers near the front edge of shelves or cabinets.
Allow at least 6 inches of clearance between the rear of the speakers and
the wall or surface behind them.
If you need to turn the speakers on their sides, position the tweeters
toward the outside.
If used on a desktop for computer speakers, it’s best if they are placed on a
solid surface.
Wireless
Page 2
Warranty Information
All Audioengine products have a 3-year Limited Warranty on parts and
labor from date of purchase. The Limited Warranty applies only to
Audioengine products purchased in the United States. Your warranty is
automatic, so there is no need to register. For Limited Warranty coverage
elsewhere, please contact the Audioengine dealer, reseller, or distributor
in your country or region.
What is covered
All defective parts or faulty workmanship.
What is not covered
The Audioengine Limited Warranty does not cover damage caused by
accident, misuse, abuse, neglect, excessive moisture, lightning, power
surges, other acts of nature, unauthorized product modication or
repairs, or failure to follow the instructions outlined in this guide.
What we will do
We will repair or replace any defective parts, at our option, within a
reasonable amount of time and free of charge any time during the
warranty period. After service, we will be responsible for shipping the
product back to you at our expense.
What we ask from you
You will be responsible for shipping charges to Audioengine or to an
authorized dealer. We recommend you keep the original shipping
materials to prevent shipping damage if service is needed. Audioengine
cannot be responsible for any damages incurred during shipping due to
poor packing, so please pack well and make sure to insure your
shipment.
How to obtain Audioengine warranty service
If you have any questions or feel you may need service, contact the
reseller where you purchased your product. You can also visit our support
portal at support.audioengineusa.com where you will nd a searchable
Knowledge Base, and if you don’t nd an answer to your question you can
easily contact us by opening a support ticket.
We will do everything we can to answer your questions and resolve any
issues as quickly as possible.
Exclusive remedy
This Limited Warranty is fully transferable provided the current owner
furnishes the proof of purchase and that the serial number on the
product is intact. THE MAXIMUM LIABILITY OF AUDIOENGINE SHALL NOT
EXCEED THE ACTUAL PURCHASE PRICE PAID BY YOU FOR THE PRODUCT.
IN NO EVENT SHALL AUDIOENGINE BE LIABLE FOR SPECIAL, INCIDENTAL,
CONSEQUENTIAL OR INDIRECT DAMAGES.
Product returns and refunds
We sincerely hope you get as much enjoyment from our products as
we've had creating them. However, should you have an issue or are not
satised with any Audioengine product for any reason contact the
reseller where you purchased or contact us directly:
http://support.audioengineusa.com/support/home
About Audioengine
Audioengine designs and builds innovative audio products with all your
music in mind. Great sound, simple but elegant designs, high-quality
materials and truly useful features are what Audioengine is about. We
sincerely hope you get as much enjoyment from our products as we’ve
had creating them!
Information for Users on Disposal of Old Equipment
[European Union]
This symbol indicates that the electrical and electronic
equipment should not be disposed as general household waste
at its end-of-life. Instead, the product should be handed over to
the applicable collection point for the recycling in accordance
with your national legislation.
By disposing of this product correctly, you will help to conserve the
environment and human health that could otherwise be caused by
inappropriate waste handling of this product. For more information about
collection point and recycling of this product, please contact your household waste disposal service or the shop where you purchased the product.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in accordance with
applicable national legislation or other rules in your country for the
treatment of old electrical and electronic equipment.
FCC Part 15 Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
© 2017 Audioengine, LLC. All Rights Reserved.
Audioengine and Audioengine A5+ Wireless are trademarks of Audioengine.
The Bluetooth name and the Bluetooth trademarks are owned by Bluetooth SIG,
Inc. and are used by Audioengine under license.
The aptX® mark and logos are registered trademarks of CSR plc.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc.
A5+ Wireless (left) speaker front A5+ Wireless (left) speaker rear
Volume
Control
Power
Indicator
Remote
Receiver
115
Mute
Press the Mute button to
silence the A5+ Wireless.
The front panel indicator
will blink showing that the
speaker is muted.
Mute may also be cancelled
by pressing the Volume (+)
or (-) or by turning the front
panel volume knob.
Volume
Press Volume (+) or (-)
to adjust the A5+
Wireless volume level.
Sleep
Sleep mode is a
power-saving feature,
shown by a slow pulse
of the front panel
power indicator. To
exit Sleep, press the
Sleep button again.
You can also put the
A5+ Wireless into and
out of Sleep by
pressing the front
panel volume knob.
Replacing the battery
If the remote control isn’t working or is slow to respond, the
battery may need to be replaced. To access the battery, insert a
paper clip into the hole on the back of the remote.
Remote Control
Stereo
inputs &
ouputs
Output
to passive
right speaker
Power inlet
Fuse
Voltage select
Power switch
Stereo
mini-jack
input
Bluetooth
Pair button
Wireless
antenna
Loading...