Attwood Toggle Switch User Manual

Toggle Switch

7589 Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69306 Rev. B 03-10

REQUIRED FOR INSTALLATION

• Drill with ⁷⁄₁₆" (11mm) dia. bit.

• Slotted screwdriver.

• Terminal crimpers.

APPLICATION

• Install switch in dashboards or panels up to ¹⁄₈" (3mm) thick.

• Switch requires 1⁵⁄₈" (41mm) depth behind panel.

• Rated load is 5 amps.

MOUNTING INSTRUCTIONS

1. Insert power source wire and switched wire into provided spade terminals. Crimp terminals with tool. Attach spade terminals to switch terminals.

2. Remove knurled nut from switch shaft.

3. In desired location, drill ⁷⁄₁₆" (11mm) diameter hole through dash panel. From inside panel, insert shaft through hole.

4. Tighten knurled nut onto end of shaft. From inside, tighten chrome nut against panel. Do not overtighten.

Note: All loads must be properly fuse protected.

Figure 1

⁷⁄₁₆" (11mm) Diameter

•

Chrome Nut

Knurled Nut

• Panel: ¹⁄₈" (3mm) Max.

•

Spade Te r minal