Attwood Quasar 69303, Quasar 3200 User Manual

#8 Stainless

Steel Fasteners

Quasar Light

Pole Base

1/4" Spade

Deck Gasket or

Non-Silicone Sealant

Connectors

Boat Centerline

•

Figure 1

•

Bow

wires to base using 1/4" spade connectors.

4. Bring 12VDC (+) and (-) wires up through deck hole. Connect

5. Apply deck gasket or non-silicone sealant to underside of base.

6. Align and fasten base with #8 stainless screws. Do not over tighten.

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Light Pole Base

3200 and 3500 Series

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other

for quality replacement parts and marine accessories.

best-known boat manufacturers as original equipment. Look to Attwood

marine accessories are specified more than any other brand by America’s

SAVE THESE INSTRUCTIONS

Form Number 69303 Rev. C 03-11

REQUIRED FOR INSTALLATION

• Drill with 1/8" (3mm) and 1-1/16" (27mm) bits

• Screwdriver

non-silicone sealant

• Three #8 stainless steel fasteners (not countersunk)

• Deck Gasket for 3200 Base (Attwood #910411) or

LOCATION

hole with boat centerline. Mark location of all 3 screw holes.

If base is used for a red/green bow light, locate in an unobstructed

area as far forward as possible. Center of the base must be aligned

with the centerline of the boat.

INSTALLATION

1. On boat centerline, mark and drill 1-1/16" (27mm) diameter hole.

Remove base.

2. Insert base into hole with hinge toward bow. Align center screw

3. Drill 1/8" (3mm) pilot holes.