Attwood Mile Navigation Lights User Manual

12-Volt 1-Mile Navigation Lights

66314 Series

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment.

Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69338 Rev. B 03-10

FEATURES

Your new Attwood 12-Volt, 1-Mile Vertical Mount Navigation Sidelights are for boats up to 39.6 ft. (12 meters). highly-polished, corrosion resistant stainless steel. completely encapsulates the bulb and socket assembly for a splash resistant seal. These lights meet the ABYC A-16 standard.

REQUIRED FOR INSTALLATION

• Cordless drill with suitable bits.

• Phillips head screwdriver.

• Marine sealant.

Housing

Lens and

s are of

gasket

Figure 2

1/8" (3mm) Pilot Holes

•

Butt Joint Connectors

Mounting Screw

•

3/4" (19mm) Dia. Hole

FINAL WIRING CAUTION:

Power source must be positive 12V DC only. All positive (+12V DC) wires must be fused with a 2-amp fuse to protect the circuit. make proper connections and fusing will void product warranty.

1. Neatly thread wires to dash avoiding any areas where abrasion or snagging may occur.

2. Use waterproof crimp on butt joint connectors to attach wires to a switch on the dash that allows for two-position operation — one for running lights and one for anchor lights. Test lights for proper operation. (Figure 3)

Figure 3

•

Bulb

Base

3-Way Switch

•

Gasket

Lens

•

Housing

Failure to

•

WARNING:

To prevent personal injury, always disconnect the power source when installing or servicing this product. Always remove the boat from the water before using 120V AC power tools.

LOCATION

Lights must be mounted to an unobstructed smooth vertical surface on the exterior cabin bulkhead or superstructure parallel to the water line. Red to port (left) and Green to starboard (right). (Figure 1)

Figure 1

112.5°

Red Port

INSTALLATION

1. Using base as a template, mark the center location of the bulb socket opening in the base and all mounting screw holes.

2. Drill 3/4" (19mm) diameter hole for bulb socket and 1/8" (3mm) pilot holes for all mounting screws.

3. Bring 12V DC (+) and (-) wires up through hole.

4. Connect wires using waterproof crimp on butt joint connectors.

5. Activate light to verify proper operation.

6. Snap bulb socket into opening in base.

7. Apply marine sealant to the bottom of base around bulb socket to prevent water from entering hull or cabin.

8. Push wires and bulb socket into 3/4" (19mm) hole and align screw holes.

9. Align gasket, lens and housing with base and fasten with stainless screws. Do not over tighten. (Figure 2)

112.5° Green Starboard

2-Amp Fuse

•

Neg. (-)

Pos. (+)

•

12V DC

Green Starboard Red Port

MAINTENANCE

For cleaning or to replace bulb, remove three screws in housing. Remove housing, lens and gasket. Push bulb in and turn counterclockwise to remove. Replace with 7.5 watt Attwood #8020-15. Reinstall assembly and tighten screws. (Figure 2)

This product carries the standard Attwood one year warranty. See Product Catalog for details.