Attwood Fold-Up Drink Holder Dual Ring User Manual

Drink Holder

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories.

Form Number 69275 Rev. B 03-10

Required for Installation

• Drill with 1/8" bit

• Four #10 stainless steel flathead screws (sold separately)

Figure 1

1. Open the cover and flip both holder rings up.

2. Position the drink holder on the desired flat surface, holder rings on top.

3. Using the four mounting holes as a template, mark pilot holes.

4. Drill four pilot holes.

5. Attach drink holder with four #10 stainless screws.

Figure 1

Mounting Holes (4)

•

Both Holder Rings Up

#10 Stainless Steel

•

Flathead Screws

•

Cover Open

Figure 3

Flip small ring up, large ring down to hold 12 oz. can or small cup.

Figure 4

Flip large ring up, small ring down to hold beverage cooler, mug, or large cup.

When not in use, flip both rings down and close cover.

Figure 4Figure 3

Dimensions

A. 4-9/16" B. 4-5/8" C. 3-1/16" D. 1-7/8" E. (Closed) 15/16" F. (Open) 4-3/4"

Figure 2

Holder rings flip up and down individually for different container sizes.

Figure 2

Small Holder Ring

•

Large Holder Ring

•