AT&T TL760 User Manual

Quick start guide

TL7610/TL7611

DECT 6.0 cordless headset

Getting started

Battery installation

Install the battery as shown below. After installing the battery,
you may be able to make and receive short calls. For optimal
performance, charge the headset battery for at least six hours
before use. When not in use, recharge the headset by returning it
to the headset base.

1. Press on both sides of the battery
compartment cover and lift the
cover up and off.

2. Insert the battery into the battery
compartment.

3. Push the battery plug into the
connector inside the compartment
and place the wires neatly insideplace the wires neatly inside
the compartment.

4. Insert the tab on the bottom of
the battery cover into the battery
compartment. Press down gently
on the battery cover until it snaps
into place.

NOTE: Remove the ear hook from the headset before battery replacement.

1

Getting started

Battery charging

After installing the battery, charge the headset by placing it in
the headset base as shown below. The headset ON/OFF light will
be on when the headset is charging.

Push

ON/OFF light

Insert

1. Insert the headset into the
headset base.

2. Push the headset downward

until the ON/OFF light on the
headset turns on.

IMPORTANT INFORMATION

Use only the supplied rechargeable battery or replacement
battery (model BT191545). To obtain a replacement battery, call

1 [phone]. In Canada, dial 1 [phone].

2

Getting started

Installation preparation

If you subscribe to high-speed Internet service (Digital Subscriber
Line - DSL) through your telephone lines, you must install a DSL
filter between the telephone line cord and the telephone wall jack.
The filter will prevent noise and caller ID problems caused by DSL
interference. Please contact your DSL service provider for more
information about DSL filters.

For customer service or product information, visit our website at

www.telephones.att.com or call 1 [phone]. In

Canada, dial 1 [phone].

Avoid placing the headset base too close to:

• Communication devices such as: television sets, VCRs, or other
cordless telephones.

• Excessive heat sources.

• Noise sources such as a window with traffic outside, motors,
microwave ovens, refrigerators, or fluorescent lighting.

• Excessive dust sources such as a workshop or garage.

• Excessive moisture.

• Extremely low temperature.

• Mechanical vibration or shock such as on top of the washing
machine or work bench.

3

Getting started

Headset base installation

IMPORTANT: If you purchased model TL7611, see the TL7000
handset lifter manual for installation instructions.

Optional accessories

It is recommended that you install a handset lifter (model TL7000)
and/or a dial pad (model TL7601) with your headset. The following
optional accessories are compatible with your headset and base:

The TL7000 is a handset lifter with ring detector.

•
The TL7601 is a dial pad that allows you to dial numbers and

•
place calls when away from your telephone. The dial pad will
also allow you to use the headset as a stand-alone product
without a connection to a telephone.

The TL7600 is an expansion headset (up to two headsets can

•
be used with the same headset base).

Visit our website www.telephones.att.com for more
information about these products or to download user manuals.

TL7000 TL7601 TL7600

4