AT&T TL72308, TL72208 User Manual
Quick start guide
TL72108/TL72208/
TL72308/TL72408
5.8 GHz cordless
telephone/answering system
with caller ID/call waiting
Installation preparation
You must install and charge
the handset battery before
using the cordless handset.
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack (see page 2). The filter will prevent
noise and caller ID problems caused by DSL interference. Please contact your
DSL service provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset or
telephone base display - remove it before use.
For customer service or product information, visit our website at
STOP!
See page 2
for easy instructions.
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base too close to:
• Communication devices such as: television sets, VCRs, or other cordless
telephones.
• Excessive heat sources.
• Noise sources such as a window with traffic outside, motors, microwave ovens,
refrigerators, or fluorescent lighting.
• Excessive dust sources such as a workshop or garage.
• Excessive moisture.
• Extremely low temperature.
• Mechanical vibration or shock such as on top of the washing machine or work
bench.
1
Telephone base and charger installation
WALL
WALL
DESK
DESK
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
Install the telephone base as shown below.
1. Plug the small
end of the larger
power adapter into
the power jack at
the bottom of the
telephone base.
DSL filter (not included),
required if you have DSL highspeed Internet service.
5. Plug the other end
of the telephone line
cord into a telephone
jack.
Charger installation
1. Plug the small end
of the smaller power
adapter into the jack
on the underside of the
charger, then route the
cord through the slot
as shown.
Telephone
line cord
Telephone
wall jack
2. Plug one end of
3. Route cords
Power
adapter
4. Plug the large
2. Plug the large end
of the smaller power
adapter into a power
outlet not controlled
by a wall switch.
the telephone
line cord into the
telephone jack at
the bottom of the
telephone base.
through slots.
end of the
larger power
adapter into a
power outlet not
controlled by a
wall switch.
IMPORTANT INFORMATION
Use only the power adapter supplied with this product. To order a replacement
1.
power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
2
Loading...