AT&T TL32350, TL32250 User Manual
Quick start guide
TL32100/TL32200/TL32250/
TL32300/TL32350
DECT 6.0 cordless telephone/
answering system with
caller ID/call waiting
You must install and charge
the battery before using the
cordless handset.
See pages 2-4 for easy
instructions.
Install the telephone base close to a telephone wall jack and an electrical
outlet not controlled by a wall switch. The telephone base can be placed on
a flat surface or vertically mounted on the wall (see Wall mount installation
in the user’s manual). For optimum range and better reception, place the
telephone base in a central and open location.
If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line, you must install a DSL filter between the telephone
line cord and the telephone wall jack (page 2). The filter prevents noise and
caller ID problems caused by DSL interference. Please contact your DSL service
provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset
or telephone base display - remove it before use.
For customer service or product information, visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base too close to:
Communication devices such as television sets, VCRs, or other
•
cordless telephones.
Excessive heat sources.
•
Noise sources such as a window with traffic outside, motors, microwave
•
ovens, refrigerators, or fluorescent lighting.
Excessive dust sources such as a workshop or garage.
•
Excessive moisture.
•
Extremely low temperature.
•
Mechanical vibration or shock such as on top of a washing machine or
•
work bench.
1
Telephone base and charger installation
Install the telephone base and charger as shown below. If you subscribe
to high-speed Internet service (DSL - digital subscriber line) through your
telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
The telephone base comes ready for tabletop use. If you want to mount
your telephone on a wall, refer to Wall mount installation in the user’s
manual for details.
Electrical outlet not
Telephone wall jack
controlled by a wall
switch
Plug the other end of
the telephone line cord
into a telephone wall
jack.
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service.
Telephone line cord
Route the cords
through the slot.
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Route the cord through
the slot.
Ensure the small end
of the smaller power
adapter is plugged into
the power jack on the
back of the charger.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Plug one end of the
telephone line cord
into the TEL. LINE jack
on the back of the
telephone base.
Plug the small end
of the larger power
adapter into the power
jack on the back of the
telephone base.
Raise the antenna.
IMPORTANT INFORMATION:
Use only the power adapters provided with
•
this product. To obtain a replacement, visit our
website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada,
dial 1 (866) 288-4268.
The power adapters are intended to be
•
correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold
the plug in place if they are plugged into a
ceiling or an under-the-table or cabinet outlet.
2
Loading...