AT&T CL82859, CL82509, CL82359, CL82659, CL82109 User Manual

Quick start guide

CL82109/CL82209/CL82309/
CL82359/CL82409/CL82509/
CL82609/CL82659/CL82859
DECT 6.0 corded/cordless
telephone/answering system
with caller ID/call waiting

Installation

You must install and charge the
handset battery before using the
cordless handset.

Install the telephone base close to a telephone jack and a power outlet not
controlled by a wall switch. The telephone base can be placed on a flat
surface or vertically mounted on the wall. For optimum range and better
reception, place the telephone base in a central and open location.

If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack (see the following page). The
filter prevents noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more information about DSL
filters.

Your product may be shipped with a protective sticker covering the handset or
telephone base display - remove it before use.

For customer service or product information, visit our website at

STOP!

See page 3-4 for easy instructions.

www.telephones.att.com or call 1 [phone]. In Canada, dial
1 [phone].

Avoid placing the telephone base too close to:

• Communication devices such as: television sets, VCRs, or other cordless
telephones.

• Excessive heat sources.

• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting.

• Excessive dust sources such as a workshop or garage.

• Excessive moisture.

• Extremely low temperature.

• Mechanical vibration or shock such as on top of the washing machine or
workbench.

1

Telephone base & charger installation

Install the telephone as shown below.

The telephone base is ready for tabletop use. If you want to change to wall
mounting, see user’s manual for details.

1. Plug one end of
the telephone line
cord into the
telephone jack on
the bottom of the
telephone base.

7. Raise the antenna.

6. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.

2. Route the power adapter cord through the slot.

Telephone line
cord

Power
adapter

If you have DSL high
speed Internet
service, a DSL filter
(not included) is
required.

5. Plug the large end of
the power adapter
into a power outlet
not controlled by a
wall switch.

3. Plug the small
end of the
telephone base
power adapter
into the power
jack on the
bottom of the
telephone base.

4. Place the cords
into the
channels.

Charger
installation

Plug the power adapter
into an electrical outlet
not controlled by a wall
switch.

IMPORTANT INFORMATION

1. Use only the power adapter(s) supplied with this product. To order a replacement power

adapter, visit our website at

www.telephones.att.com, or call

1 [phone]. In Canada, dial 1 [phone].

2. The power adapters are intended to be co rrect ly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under­the-table or cabinet outlet.

2