AT&T CL82400 User Manual
Quick start guide
CL82100/CL82200/CL82250/
CL82300/CL82350/CL82400/
CL82450/CL82500/CL82550/
CL82600
DECT 6.0 cordless telephone/
answering system with
caller ID/call waiting
Installation
You must install and
charge the battery before
using the telephone.
Install the telephone base close to a telephone jack and a power outlet not
controlled by a wall switch. The telephone base can be placed on a flat surface
or vertically mounted on the wall. For optimum range and better reception,
place the telephone base in a central and open location.
If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack (see the following page). The
filter prevents noise and caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset
or telephone base display - remove it before use.
For customer service or product information, visit our website at
STOP!
See pages 2-4
for easy instructions.
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base too close to:
Communication devices such as: television sets, VCRs, or other
•
cordless telephones.
Excessive heat sources.
•
Noise sources such as a window with traffic outside, motors, microwave
•
ovens, refrigerators, or fluorescent lighting.
Excessive dust sources such as a workshop or garage.
•
Excessive moisture.
•
Extremely low temperature.
•
Mechanical vibration or shock such as on top of the washing machine
•
or workbench.
1
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use.
Telephone base installation
Plug the other end
•
of the telephone
line cord into a
telephone jack or
a DSL filter.
Telephone line cord
Raise the antenna.•
Power
adapter
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Plug one end of the
•
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
Plug the small end of
•
the telephone base
power adapter into the
power adapter jack
on the bottom of the
telephone base.
Route the power
•
adapter cord through
this slot.
Place the cords into
•
the channels.
Plug the large end
•
of the power adapter
into a power outlet
not controlled by a
wall switch.
Charger installation
Plug the power adapter into an electrical outlet
not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
2
Loading...