AT&T CL81209 User Manual
Quick start guide
CL81109/CL81209/
CL81219/CL81309
DECT 6.0 cordless
telephone with caller ID/
call waiting
Installation
You must install and charge
the battery before using the
telephone.
Install the telephone base close to a telephone jack and a power outlet not
controlled by a wall switch. The telephone base can be placed on a flat surface
or vertically mounted on the wall (read the user’s manual for details). For
optimum range and better reception, place the telephone base in a central and
open location.
If you subscribe to high-speed Internet service (digital subscriber line DSL) through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack (see the following page). The
filter prevents noise and caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset or
telephone base display - remove it before use.
For customer service or product information, visit our website at
STOP!
See pages 4-5
for easy instructions.
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base too close to:
Communication devices such as: television sets, VCRs, or other cordless
•
telephones.
•
Excessive heat sources.
Noise sources such as a window with traffic outside, motors, microwave
•
ovens, refrigerators, or fluorescent lighting.
•
Excessive dust sources such as a workshop or garage.
Excessive moisture.
•
•
Extremely low temperature.
Mechanical vibration or shock such as on top of the washing machine or
•
workbench.
1
Telephone base installation
Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, read the user’s manual for details.
2. Route the power
1. Plug the small end
of the power adapter
into the power jack
on the bottom of the
telephone base.
7. Raise the antenna.
adapter cord
through the slot.
3. Plug one end of the
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
4. Place the cords into
the channels.
6. Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
If you have
DSL high speed
Internet service,
a DSL filter (not
included) is
required.
5. Plug the other end
of the telephone line
cord into a telephone
jack or a DSL filter.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
2
Loading...