Instruction
Manual
Part No. AWGCV30
1-877-80-PONDS
www.atlanticwatergardens.com
Assembly of the AWGCV30 Check Valve
The Atlantic AWGCV30 is adaptable to many different
situations. The body of the check valve is offset so it can be
placed close to the body of the pump. Depending on the needs
of the installation, the elbow can be placed in one of two different ways to accommodate width or
height restrictions.
For those applications with height restrictions, glue the
insert portion of the elbow directly into the top of the check
valve. Make sure to find the arrow marking the direction of flow
through the check valve. It should point up and away from the
pump. The rubber boot will go onto the pipe stub (Figure 1).
The elbow will run over the top of the pump in this installation.
A male thread adapter and a pipe stub (not included) will be
needed to complete the connection to the pump. This set up is
recommended for the PV2300 Pump Vault.
Rubber boot
Elbow
Check Valve
Figure 1.
2
For those applications with width restrictions, glue the pipe stub
directly into the check valve. Make sure to find the arrow marking
the direction of flow through the check valve. It should point up
and away from the pump. The rubber boot will go onto the elbow
directly (Figure 2). The elbow will run over top of the pump in this
installation. A male thread adapter and a pipe stub (not included)
will be needed to complete the connection to the pump. This set
up is recommended for the PS15000 Skimmer, PV1800 Vault with
Extension, and PV2300 Vault with Extension.
Flow Direction
Indicator
Figure 2.
3
1-877-80-PONDS
www.atlanticwatergardens.com
Loading...