ATEN Technology UE-250 User Manual

User Manual

UE-250

Read this manual thoroughly and follow the installation and

operation procedures carefully to prevent any damage to the

unit, and/or any of the devices connected to it.

This package contains:

M 1 UE-250 USB 2.0 Repeater Cable

M 1 User Manual

International Co., Ltd.

Manual Part No. PAPE-1240-100

If anything is damaged or missing, contact your dealer.

Printed in Taiwan 10/2003

All brand names and trademarks are the registered property of their respective owners

Function Specification

Power Supply Bus Powered

Cable length (output) 5 m (16ft.)

specifications

Connectors 1 Type A Male

- 5 -

1 Type A Female

USB Specification 2.0 spec. for high, full and low

Driver Support Native Driver Support

Operating Temperature 5° - 40° C

Storage Temperature -20° - 60° C

Humidity 0% - 80% RH, NC

Weight 255g

Limited Warranty

IN NO EVENT SHALL THE DIRECT VENDOR’S LIABILITY EXCEED

THE PRICE PAID FOR THE PRODUCT FROM DIRECT, INDIRE CT,

SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING

FROM THE USE OF THE PRODUCT, DISK, OR ITS DOCUMENTATION.

The direct vendor makes no warranty or representation, expressed,

implied, or statutory with respect to the contents or use of this

documentation, and especially disclaims its quality, performance,

merchantability, or fitness for any particular purpose.

The direct vendor also reserves the right to revise or update the device or

documentation without obligation to notify any individual or entity of such

revisions, or update. For further inquiries, please contact your direct

Reset the device by

unplugging the cable and

then plugging it back in or

use external power to your

linked devices.

vendor.

- 4 -

port or a USB hub.

Installation

Installation is simply a matter of plugging in the cables:

1. Plug the UE-250 USB cable into the computer’s USB

2. Plug the USB peripheral into the UE-250 socket.

Static electricity or

insufficient power

may cause the

device to operate

erratically.

That’s all there is to it.

Problem Cause Solution

Device

operates

Troubleshooting

erratically

- 3 -

Components

or hub

1. Built in cable with USB connection to USB port on PC

2. LED (green) indicates USB link

3. Type A female USB port for connection from peripheral

4. LED (red) indicates overcurrent

- 2 -

Host Controller, but in that case, it only

can support data transfer speeds of up to 480

Mbps; all others only support speeds of up to

12 Mbps.

supports USB 1.1 speeds (1.5 - 12 Mbps).

Overview

The UE-250 USB Repeater Cable allows you to extend

the distance between your computer and your USB

peripherals by 5 meters (16’). Unlike typical cables, the

UE-250 is an active extension cable. All USB signals

NOTE: This equipment has been tested and found to

signals to maintain optimal signal integrity

transmitted through it are regenerated to maintain optimal

signal integrity to meet the USB 2.0 specification.

comply with the limits for a Class B digital device

pursuant to Subpart J of Part 15 of FCC Rules. These

limits are designed to provide reasonable protection

against harmful interference in a residential

installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will

Features

M Extends the distance to USB devices by 5 m (16’)

M Embedded custom ASIC regenerates transmitted USB

and receiver.

not occur in a particular installation. If this equipment

does cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to

correct the interference by one or more of the

following measures:

M Reorient or relocate the receiving antenna.

M Increase the separation between the equipment

M Connect the equipment into an outlet on a circuit

Note: Only systems with a USB 2.0 driver installed

or higher

System Requirements

M Whistler; Windows: XP, 2000, Me, 98 SE; Mac OS 8.6

different from that which the receiver is connected.

radio/television technician for help.

M Consult the dealer or an experienced

Note: The UE-250 can be connected to a USB 1.1

M USB 2.0 Host Controller installed on the system.

- 1 -