Page 1
High Voltage Pulse Generator
These very short rise time pulse generator use only solid state switches. The peak output
voltage can reach 5, 20 or 30 kV on 50 ohm. A BNC 50 ohm connector produces triggering
signals when the generator is internally triggered (internal mode). When the generator is in
external mode, the HV pulse is only delivered when a synchronisation signal is present at this
connector. In internal trigger mode, the repetition frequency is adjustable by a rotary knob up to
10 kHz, respectively 1 kHz. The output voltage is also adjustable by a rotary knob.
SPECIFICATIONS
Type GP5-01-05 GP20-01-2 GP30-01-2
Maximum output voltage
Peak current
Impedance
Rise time 15 - 95 %
Pulse width at 50 %
Jitter
Pulse repetition freq.
Lifetime of the generator
Max. power into the load
Connector type
Triggering
Trigger signal
Cooling
Power supply
Weight
Size (L x W x H)
5 kV (on 50 ohm) 20 kV (on 50 ohm) 30 kV (on 50 ohm)
100 A (on 50 ohm) 400 A (on 50 ohm) 600 A (on 50 ohm)
50 ohm 50 ohm 50 ohm
105 ps +/- 5 ps 130 ps +/- 10 ps 130 ps +/- 10 ps
500 ps +/- 100 ps 600 ps +/- 100 ps 600 ps +/- 100 ps
30 - 40 ps 30 - 40 ps 30 - 40 ps
≤ 10 kHz ≤ 10 kHz ≤ 1 kHz
> 1011pulses > 1011pulses > 1011pulses
2.5 W (at 10 kHz) 50 - 70 W (at 10 kHz) 10 W (at 1 kHz)
HVM50K (other on
request)
internal or external
BNC connector 50 ohm
TTL, rise time 5-10 ns,
pulse width 0.1-1 us
air air air
100 - 240 Vac/ 200 W 100 - 240 Vac/ 200 W 100 - 240 Vac / 300 W
10 kg 10 kg 14 kg
48 x 45 x 12 cm
(19" housing)
HN (other on request) HVM50K
internal or external
BNC connector 50 ohm
TTL, rise time 5-10 ns,
pulse width 0.1-1 us
48 x 45 x 12 cm
(19" housing)
internal or external
BNC connector 50 ohm
TTL, rise time 5-10 ns,
pulse width 0.1-1 us
48 x 45 x 12 cm
(19" housing)
Other models are available on request.
montena technology - 1728 Rossens - Switzerland - phone + 41 26 411 84 84 - fax + 41 26 411 17 79
www.montena.com e-mail: products@montena.com
Loading...