PH1000T
ATC ELECTRICAL & MECHANICAL
ATC House,
Broomhill Drive, Tallaght, D24 EF99
IRELAND
tel +353 1 4625111
fax +353 1 4520887
www.atc.ie sales@atc.ie
PH1000T
PH1500T
PH2000T
ATC Sunray Panel Heater
3 Year Warranty
INSTALLATION USE AND
MAINTENANCE
MANUAL
Class I - IP 20
ATC ELECTRICAL & MECHANICAL
ATC House,
Broomhill Drive, Tallaght, D24 EF99
IRELAND
tel +353 1 4625111
fax +353 1 4520887
www.atc.ie sales@atc.ie
1. IMPORTANT SAFETY INSTRUCTIONS
These instructions should be carefully read before installation and retained by
the user. The booklet must be kept and delivered to the new user in case of
disposal of the heater. The Manufacturer reserves the right to vary the features
of the product without prior notice. The technical data are indicative only.
1. This heater is intended solely for the use it has been designed for, namely
space heating. The Manufacturer or Distributor is not responsible for any
damage that could happen due to improper use.
2. After unpacking make sure that the heater is complete and shows no signs
of tampering or any visible damage
3. Keep packing materials, which are potentially dangerous, away from
children.
4. The heater can be used by children of at least 8 years (as well as by persons
with reduced physical, sensory or mental capabilities, or lack of experience or
required knowledge) provided that they are under supervision, or after they
have been instructed relating to the safe use and have understood the
potential dangers. Children should not play with the Heater.
5. Cleaning and maintenance must be performed by the user and not by
unsupervised children.
6. Children of less than 3 years should be kept away unless continuously
supervised. Children aged from 3 years and less than 8 years shall only switch
on/off the heater provided that it has been placed or installed in its intended
normal operating position and they have been given instruction concerning
use of the heater in a safe way and understand the hazards involved,
children should always be supervised.
7. Children aged from 3 years and less than 8 years shall not plugin, regulate,
clean the heater or perform maintenance.
8. Before connecting the heater make sure that the voltage is the same as
indicated on the device rating lable.
9. Do not use in presence of gas, inflammable or explosive liquids or substances
as defined in BS5345.
ATC ELECTRICAL & MECHANICAL
ATC House,
Broomhill Drive, Tallaght, D24 EF99
IRELAND
tel +353 1 4625111
fax +353 1 4520887
www.atc.ie sales@atc.ie
10. Some fundamental rules which apply to all electrical
devices must be observed when using the heater:
• Do not touch the heater with wet hands.
• Do not handle the heater when you have bare feet.
• Do not let children play with the heater.
11. Avoid the use of extension cords with this product, extension cords may
overheat and there could be a risk of fire.
12. Do not make any modification to the Heater.
13. Keep connections dry.
14. If the power supply cord is damaged, do not use the heater until the cord has
been replaced. For power cord replacement, always contact an electrician in
order to avoid any risk of injury.
15. If the heater is not going to be used for a long period, disconnect it from the
power supply.
16. Always disconnect the heater before doing any maintenance
CAUTION - Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and vulnerable
people are present.
2. ELECTRICAL INSTALLATION NOTES
The installation should always be carried out by a qualified electrician or
a competent person in accordance with the current electrical standards:
HD 384 CENELEC for Mainland Europe, IEC 60446 and BS 7671 for the
United Kingdom, IEC 60445(2010) & ET101:2008 for Ireland and IEC 60364-7-708 1988
Internationally. The energy supply to the heater must always be properly earthed.
The heater must be connected to the energy supply using the provided cable.
An overvoltage category III Combined Circuit breaker and Residual
Current Device (RCD) with rated earth leakage operation not exceeding
30mA must be fitted upstream on the supply line. The circuit breaker
must have a contact opening distance of at least 3 mm.
• The heaters should always be installed only using the mounting brackets
provided
• Under no circumstances turn the heater on if it is not mounted using the
brackets supplied or if the face of the heater is on any surface.
• The heater must not be recessed in the ceiling. There must be enough space
around the top of the heater to ensure adequate ventilation.
Loading...