ASUS Eee pc 4g 701 Service Manual Chapter-03
Assembly procedure
A
Chapter
Assembly Procedure
Please follow the information provided in this section to perform the complete
assembly procedure of the Eee PC 4G (701). Be sure to use proper tools
described before.
fter you have completed the previous chapter of complete disassembly, please follow this
chapter to assemble the Eee PC 4G (701) back together. This chapter describes the
procedures of the complete Eee PC 4G (701) assembly. In addition, in between
procedures, the detailed assembly procedure of individual modules will be provided for
your service needs.
The assembly procedure consists of the following steps:
• LCD Module
• Motherboard Module
• Top Case Module
• WLAN Module
• Keyboard Module
• Memory Module
• Battery Module
3 - 1
Assembly procedure
LCD MODULE
LCD Module
The illustrations below show how to assemble and install the LCD module of the Eee
PC 4G (701).
1. Install the two speakers on LCD back cover and arrange the speaker cable well through cable
guide.
2. Assembly the black and white antennas on LCD back cover and well arrange the antanna cables
through cable guides.
3 - 2
Assembly procedure
3. Install the camera board on LCD back cover, pay attention to the aiming pole.
4. Connect the coaxial cable with inverter board.
5. Connect the inverter cable, LCD FPC cable with inverter board.
3 - 3
Assembly procedure
6. Install the LCD panel together with the inverter board on LCD back cover and then secure 4
screws (M2*4) on it.
7. Assemble both hinges and secure 2 screws (M2*4) on each.*pay attention to differences
between the left and right.
8. Install the LCD front bezel on LCD back cover and press the sides to fix them well.
3 - 4
Assembly procedure
9. Secure 6 screws (M2*4)on LCD front bezel and then fix 6 rubber pads on it.
MOTHERBOARD
MOTHERBOARD
ASSEMBLY
Motherboard
The illustrations below show how to assemble and install the motherboard of the Eee
PC 4G (701).
1. Install the Fan module on bottom case, secure 3 screws on it and fix 1 piece of tape on the cable.
2. Hold the LCD to fix its hinges on bottom case and then secure 2 screws(M2*4).
3 - 5
Loading...