ASUS A6JM Service Manual
Disassembly Procedure
A
Chapter
Disassembly Procedure
Please follow the information provided in this section to perform the complete
disassembly procedure of the notebook. Be sure to use proper tools
described before.
SUS A6Jc/Jm Notebook consists of various modules. This chapter describes the
procedures for the complete notebook disassembly. In addition, in between procedures,
the detailed disassembly procedure of individual modules will be provided for your
service needs.
The disassembly procedure consists of the following steps:
• Battery Module
• Memory Module
• Wireless LAN Module
• HDD Module
• ODD Module
• Keyboard
• LCD Module
• Top Case Module
• Main Board Module
• Modem Module
• CPU/Heat Sink Module
2 – 1
Disassembly Procedure
BATTERY
Battery Module
The illustration below shows how to remove the battery module.
1. Unlock and hold the latches, and remove the battery.
2. Slide the battery latch (No.1) to unlock and Firmly slide the other latch (No.2) to the top and
remove the battery
SECOND
MEMORY
MODULE
MEMORY
REMOVAL
Memory Module
The A6Jc/Jm Notebook do not have onboard RAM. There are two SO-DIMM sockets
for installing SO-DIMM RAM. It can upgrade the total memory size up to 2GB with a
1GB module on each socket.
Removing Memory module
1. Remove 2 screws and remove DIMM door.
2 - 2
Disassembly Procedure
W
W
2. Take the memory DIMM cover away as the picture shows.
IRELESS LAN
MODULE
REMOVAL
IRELESS LAN
REMOVAL
Wireless Lan Module
The illustration below show show how to remove the Wireless LAN module
Disassembling Wireless Lan board.
1. Remove 2 Antenna cables from Wireless LAN Module.
2 - 3
Disassembly Procedure
2. Take the Wireless Lan away as the picture shows.
30°
HDD MODULE
HDD
MODULE
REMOVAL
HDD Module
The illustrations below show how to remove the HDD module from the notebook.
Removing HDD Module
1. Remove 1 screw and lift the HDD cover away.
2 - 4
Disassembly Procedure
2. Remove the sponch and pull the hard disk module toward the direction of the arrow and lift it
up and take it out.
OPTICAL
DRIVE
REMOVAL
ODD Module
1. Remove 2 screws.
2. Remove the Mylar.
2 - 5
CPU MODULE
REMOVAL
CPU
REMOVAL
Disassembly Procedure
3. Push the metal plate with a screw driver and pull the ODD out.
CPU Module
The illustrations below show how to remove the CPU module from the notebook.
Removing CPU
1. Remove 2 screws.
2. Remove the mylar.
2 - 6
Disassembly Procedure
3. Remove 4 screws aside the CPU. And take away the thermal module.
2
3
1
4
4. Turn the non-removable screw here 180 degrees counter-clockwise to loosen the CPU.
L
O
Unlock
LCD
MODULE
LCD
DISASSEMBLY
LCD Module
The illustrations below show how to disassemble the LCD module. The module
contains LCD panel, Inverter board, LCD Hinge bracket, Hinge cover, LCD front
cover, LCD back cover.
Disassembling LCD Module
1. Remove 3 screws on both side.
2 - 7
Loading...