Asko W8844XLW Installation

Dear Customer,

Read these instructions carefully and completely before you install the
machine. The installation should be carried out by a qualifi ed person who
is familiar with all local codes and ordinances for electrical and plumbing
connections. See also the general Safety Instructions in the Use & Care
Guide.

Cosmetic damage must be reported to the ASKO dealer within fi ve
days from the date of purchase. As soon as you unpack the machine,
thoroughly check it for cosmetic damage.

Installation Instructions for Washing Machine

DOMESTIC

INSTALLATION

Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualifi ed person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.

Cosmetic damage must be reported to your dealer within
fi ve days from the date of purchase. After unpacking the
washer, thoroughly check the unit for cosmetic damage.

LEVELING THE MACHINE

It is important that the machine is level to prevent
excessive vibrations during spin cycles. Each foot of the
washer is adjustable, so you can level the washer on any
surface. Once it is level, securely tighten the lock nuts
on the feet to prevent excessive vibration during spin
cycles.

Be sure to tighten the
lock nuts securely
when you level the
machine.

DRAIN OUTLET CONNECTION

The machine is supplied with the outlet hose already
attached. The hose should be extended over a suitable
sink edge or drain pipe at a height of 24” to 36” (610 mm
to 914 mm) above the bottom of the unit. (The lower
height is preferable.) Make sure the hose is not kinked.

24" to 36"

NOTE!

If the hose is extended, the internal diameter of the
coupling must not be less than ½”.

WAR NI NG

Do not extend the drain hose higher than 36” (914 mm)
from the bottom of the unit.

WATER SUPPLY CONNECTION

Since ASKO washers have a built-in heating element,
you only need a cold water inlet. The connection should
be made by someone who is suffi ciently skilled. Use
the hose supplied with the washer. (The inlet hose is
marked for correct connection.) The water pressure
must be in the range 15–146 PSI. A valve should be fi tted
on the water supply pipe. If a new supply pipe has been
installed for the washer, it should be fl ushed thoroughly
to remove any foreign particles that might clog the fi lter
in the fi ll valve.

ELECTRICAL INSTALLATION

The machine is delivered ready-fi tted with a plug and
is intended for connection to an ASKO Dryer, which is
equipped with a matching receptacle. The plug supplied
with the washer can only be used with an ASKO Dryer.
If the washer is used separately or with another dryer, it
must be on a separate 208-240 V single-phase circuit.

If the machine is to be used in a wet area, the supply
must be protected by a residual current device.

As supplied: 208-240 V, 60 Hz, 2000 heating element,15
A timed delayed fuse is required.

WAR NI NG

Connection to a permanently wired supply point must
be made only by a qualifi ed electrician.

NOTE!

Repairs and maintenance relating to safety or
performance must be carried out by a qualif ed
professional.

NOTE!

If the unit is installed on a second storey, follow local
building codes. We recommend installing a drip pan.

2

Customer Care Center, 1-800-898-1879, www.askona.com