Arcam Delta 280 User Manual

ARCAM
DELTA 280 TUNER

HANDBOOK

Technical specification

FM tuning range Tuning system Frequency step Presets Sensitivity (HF) Alternate channel selectivity AM suppression ratio Capture ratio Signal Strength meter
sensitivity
Frequency response
87.5 to 108.0MHz Phase-locked-loop 50kHz
20
typically 1.4uV better than 60dB better than 50dB typically 1.5dB 4 segment LED typically 2uV to 2mV 20Hz-12kHz +/-0.5dB typically -2dB at 15kHz
Ultimate S/N ratio (CCIR) Mono
Stereo
better than 75dB better than 72dB
Total harmonic distortion 96MHz reference, 22.5kHz deviation at IkHz
Mono better than 0.10% Stereo better than 0.30% (using MPX filter)
Chatmel separation (IkHz) Pilot tone suppression Output impedance Minimum recommended load
Output level Power consumption Size W/D/H mm. Weight
better than 40dB better than 50dB 25ohm
Ikohm
850mV at 75kHz deviation
12VA
430 X 230 X 84
2.2kg nett.
3.2kg packed.
Supphed accessories
E & O E.
FM dipole aerial co-ax plug adaptor mains lead
CR25 Handi-Remote control
F-Type aerial adaptor
® IF FUNCTION - When several radio
stations are situated close together on the FM frequency band, a station with a strong signal can interfere with a weak adjacent station. In order to receive the weaker station properly, a modified IF (Intermediate Frequency) filter is required. The IF function switches in a narrow bandwidth filter, allowing the Delta 280 to receive the weaker station's signal satisfactorily. To select the IF function, press the IF button. The IF LED ■will glow green. To cancel, press the IF button again.
® AUTO - Selects automatic or manual
tuning (see below). The led ■will glow
amber when AUTO is selected. If the
led is not ht manual tuning is selected.
®,® V A - Press to tune up or down through
the FM frequency band. In AUTO tuning mode the frequency display will stop automatically at a station ■with a suitably strong signal. In manual tuiung mode press and hold v or
a until the
desired frequency is displayed.
O DISPLAY - The FM frequency display,
signal strength meter and AUTO LED
can be turned off by pressing DISPLAY.
To restore the display, press DISPLAY
again.
Please Note: The two digit preset
number display and the other LEDs are not affected by the DISPLAY function.
® STOIkE - For storing up to 20 FM
stations into the preset memory. To preset stations press STOB,E and while the led glo^ws red, press the desired preset button.
® SHIFT - The Delta 280 has two banks of
ten presets. Choose the required bank
by pressing the SHIFT button. Presets
1-10 can be selected when the SHIFT
led is off and presets 11-20 when the led
Note: After pressing SHIFT to change the preset bank it ■wiU still be necessary to press the required preset button to change charmel.
0 SCAN - Plays approximately 5 seconds
of each of the 20 presets in turn. If you
■wish to continue Hstening to one of the scaimed stations, press the relevant preset button. Pressing either STORE, a (tune up) or
V (tune down) ■wUl cancel the SCAN
function.
® PRESET BUTTONS - Once all the
stations have been preset into the memory, simply press the relevant button to select the desired stations. Use SHIFT when selecting preset stations 11-20.
0 POWER - Switches the unit on and off.
® PILESET DISPLAY - Displays the
preset number of the selected station.
0 SIGNAL STRENGTH METER -
Indicates signal strength of the selected station. As several radio stations are available on more than one frequency, use the signal strength meter to help you locate the best position for each station. As a guide, two amber leds and two green leds ■wiH give adequate stereo reception. AU eight leds ■wiU give the best stereo reception ■with the least possible background noise. In most cases, you wiU need to use a roof mounted aerial cormected to the mner
■with a good quahty low loss 75ohm co axial cable to achieve the best results. The simple wire dipole aerial pro^vided is
only suitable for reception of strong local
stations.
INSTALLATION
AUDIO CONNECTIONS
© Check that your mains supply voltage
agrees with the voltage setting on the rear panel of the unit.
If your mains supply voltage is different, consult your Arcam dealer.

MAINS SAFETY

This product is normally supphed with a moulded mains plug already fitted to the lead. If for any reason the plug needs to be removed, it must be disposed of immediately and securely, as it is a potential shock hazard when inserted into a mains socket.
If the plug is removed then the remaining lead must be rewired as follows:
The blue wire must be connected to the terminal which is coloured blue or marked with the letter N.
The brown wire must be connected to the terminal which is coloured brown
or marked with the letter L.
The green and yellow wire must be
connected to the temiinal which is coloured green and yellow, or marked
with the letter E or the safety earth
symbol.
® AUDIO OUTPUTS - Both pairs of
outputs are identical. Connect one pair of them to your amplifier's TUNER input using a suitable interconnect cable. The other pair can be connected to a hi fi VCR's audio input for recording simultaneous broadcasts (simulcasts) or to a cassette deck for direct recording. Insert the red phono plugs into the sockets labelled 'R' and the other phono plugs into the sockets labelled 'L'.

AERIAL CONNECTIONS

® AERIAL SOCKETS - Connect your
aerial downlead using the supphed adaptor if necessary. Two aerial sockets are provided, enabhng you to use two separate aerial sources eg. for terrestrial FM broadcasts and Cable radio.
■ With the aerial selector switch 'IN' only the Aerial One input will be used for ah 20 presets.
® With the aerial selector switch 'OUT',
Aerial One will be used when preset 1-
10 are selected and Aerial Two when
presets 11-20 are selected.
When replacing the fuse in the supphed moulded mains plug, the integral fuse holder/cover must always be refitted.
Warning:
This apparatus must be
earthed.

MAINS SUPPLY CONNECTIONS

@ Insert the lEC fine socket of the mains
lead fuUy into the power inlet on the rear panel. Connect the other end to your mains supply.

OPERATION

® MONO - Selects mono or stereo
output. The led (hght emitting diode) wih glow red when mono is selected. If a weak station is received in stereo the background hiss can be reduced by selecting mono.

SAFETY STANDARD

® STEREO LED - Indicates stereo
reception. When tuning through the FM frequency band in stereo (auto or manual) inter-station noise and very weak signals are automatically muted. To cancel muting, select mono output
(see © MONO).
@ FM FREQUENCY DISPLAY -
Indicates the frequency of the selected FM station.
PRESET MEMORY BACK-UP - The preset memory will be retained while the tuner is connected to the mains. If the mains supply is disconnected, the memory will be retained for approximately one week.
REMOTE CONTROL FUNCTION
- The Delta 280 tuner has been designed to work with both the Arcam System Remote and 'Handi-Remote' handsets.
The System Remote accesses aU functions except automatic mning. The 'Handi-Remote' can select presets, turn the display off and control Mono or
Stereo mode.

RADIO INTERFERENCE

The Delta 280 tuner is a digital device which has been designed to very high standards of electromagnetic compatibUity.
■ This product has been designed to meet the lEC 65 international electrical safety standard.

FOR YOUR INFORMATION

The BBC pubHshes a booklet entided "Radio Transmitting Stations" which contains details
of all BBC transmitters in the UK together
with other usefiil hints and tips.
This booklet can be obtained on request by sending a large stamped addressed envelope to:-
BBC Engineering Information, White City, 201 Wood Lane, London, W12 7TS.
Tel: 01345 010313 aocal caU rate)
The Radio Authority pubhshes a booklet which contains details of all independent radio stations. This booklet can be obtained on request by sending a large stamped addressed
envelope to:-
Radio Authority,
Holbrook House,
14 Great Queen Street, London, WC2B 5DG.
Telephone: 0171 430 2724
EC COUNTRIES: This product has been designed to comply with directive
89/336/EEC.
USA: This product comphes with FCC requirements. Please refer to the Hints
and Tips booklet if you suspect a radio
interference problem.
ARCAM
Pembroke Avenue, Waterbeach,
Cambridge CBS 9PB. England.
Telephone: (01223) 440964
Fax: (01223) 863384
Issue 395/1
SH050
Loading...