American Power Conversion Smart UPS SUA3000XL, Smart UPS 230 Vac, Smart UPS 120 Vac, Smart UPS 3000 VA XL, Smart UPS 208 VAC User Manual

User Manual English

APC Smart-UPS® XL

2200/3000 VA XL

120/208/230 VAC

Tower/Rack-Mount 5U

Uninterruptible Power Supply

990-2975 09/2006

Introduction

About this UPS

The American Power Conversion (APC®) Uninterruptible Power Supply (UPS) provides protection for
electronic equipment from utility power blackouts, brownouts, sags and surges. The UPS filters small utility
line fluctuations and isolates electronic equipment from large disturbances by internally disconnecting from
utility line power. The UPS provides continuous power from the internal battery until utility power returns to
safe levels or the battery is fully discharged.

Unpack

Read the Safety Guide before installing the UPS.

Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage.

The packaging is recyclable; save it for reuse or dispose of it properly.

Check the package contents:

•UPS

•Front bezel

•Literature kit containing:
– EPO connector
– Serial cable
– USB cable
– Eight ornamental screws for

securing the unit in the rack

– Eight 5/16 in (.8 cm) pan-head

screws for attaching cleats to the
chassis rails
(required for four post rack only)

– Eight 5/8 in (1.6 cm) pan-head

screws for attaching rack-mount
brackets to the unit

– Eight snap-on speed nuts
– Two rail cleats (required for four post

rack only)
– Two rack-mount brackets
– Product documentation
– Smart-UPS® User Manuals CD
– PowerChute® Business Edition CD
– Safety information
– Warranty information

Additional contents for
230 V models:

– APC power cable
– Alternate input power cord

(UK customers)
–IEC Power cord
– IEC jumper cables

Specifications

Temperature

Operating
Storage

32° to 104° F (0° to 40° C)
5

° to 86° F (-15° to 30° C) charge the UPS battery every six months

86

° to 113° F (30° to 45° C) charge the UPS battery every three months

Maximum
Elevation

Operating
Storage

Humidity

Wei ght

Maximum Number of External Battery Packs Supported by the
Smart-UPS XL

10,000 ft (3,000 m)
50,000 ft (15,240 m)

0 to 95% relative humidity, non-condensing

142 lbs (64 kg) with battery module
89 lbs (40 kg) without battery module
27 lbs (12 kg) each battery module

NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an additional label
is located on the chassis under the front bezel.

Smart-UPS 2200/3000 VA XL 120/208/230 VAC Tower/Rack-Mount 5U User Manual 3

This unit is intended for indoor use
only. Select a location sturdy enough
to handle the weight.

Do not operate the UPS where there
is excessive dust or the temperature
or humidity are outside the specified
limits.

Environmental factors impact battery
life. High temperatures, poor utility
power, and frequent, short duration
discharges will shorten battery life.

142 lbs (64 kg)

10

Installation

The UPS is shipped in tower configuration.

Tower Configuration

Connect the battery.

After the battery has been connected, tuck the battery cables in between the battery and the
battery door. This will ensure a secure fit of the bezel to the unit.

4 Smart-UPS 2200/3000 VA XL 120/208/230 VAC Tower/Rack-Mount 5U User Manual

Rack-Mount Configuration

This unit is intended for mounting in a two post rack. To order a four post rack-mount kit contact your dealer or
refer to the APC Web site, www.apc.com.

Tower to rack-mount conversion procedure

The UPS and the battery modules are heavy. Remove the battery modules to lighten the UPS during
installation.

Pull the battery disconnect
strap attached to the battery
connector. DO NOT pull
the battery cables to
disconnect the battery.

Battery
Disconnect
Strap

Remove the top cover and .
Remove and rotate the display

panel .

Foam
Spacer

Disconnect
Battery

Four post rack-mount
bracket position

Two post rack-mount
bracket position

x4

5/8 in

1.6 cm

A four post rack configuration requires installation
of two brackets in the forward position (see diagram
above), two cleats (supplied with this unit), and the
four post rails. The rails can be ordered through the
APC Web site www.apc.com.

Smart-UPS 2200/3000 VA XL 120/208/230 VAC Tower/Rack-Mount 5U User Manual 5

Install unit in rack

Ensure rack stability prior to installing devices in the rack.

The UPS should be installed at or near the bottom of the rack. If external battery packs are to be installed in the
rack, the UPS must be the top unit in the configuration.

Connect
Battery

x4
Ornamental

Foam Spacer

After all of the batteries have been connected, tuck the battery
cables in between the batteries and the battery doors. This will
ensure a secure fit of the bezel to the unit.

Accessories

This UPS is equipped with an accessory SmartSlot. Refer to the APC Web site, www.apc.com for available
accessories.

If a standard accessory, such as a Network Management card is to be installed on this UPS, refer to the Utility
CD for user documentation.

Install accessories prior to connecting power to the UPS.

6 Smart-UPS 2200/3000 VA XL 120/208/230 VAC Tower/Rack-Mount 5U User Manual