APC CTSLLP-G User Manual

Pole and Ground Mount Standby Power Supply Enclosures

BroadBand
CTSLLP/G Series

User Manual

990-5517 04/2003

Chapter 1 General Information

The CTSLLP/G Standby Power Supply Series Enclosures provide a power source for broadband
cable operations.

Safety

This Safety Guide contains important instructions that should be followed during installation and
maintenance of the APC equipment and batteries. It is intended for APC customers who setup,
install, relocate, or maintain APC equipment.

Changes and modifications to this unit not expressly approved by APC could void the
warranty.

Failure to observe these warnings may result in serious injury, death or damage to the
equipment.

Electrical
Warnings

Lifting

Warnings

Overhead
Warnings

• Do not work alone under hazardous conditions.

• Do not handle any metallic connector before the power has been

disconnected.

• Servicing this equipment may require working with protective covers
removed and utility power connected. Use extreme caution during these
procedures.

• High current through conductive materials could cause severe burns.

• When grounding cannot be verified, disconnect the equipment from the

utility power outlet before installing or connecting to other equipment.
Reconnect the power cord only after all connections are made.

• Check that the power cord(s), plug(s), and sockets are in good condition.

• Replacement of fuses or other parts must be with identical types and

ratings. Substitution of nonidentical parts may cause safety and fire
hazards.

• These units are heavy. Use proper lifting techniques and equipment to
avoid injury.

• Never stand underneath anything while it is being hoisted.

• Always wear a hardhat.

1

Specifications

Environmental Specifications

Operating Temperature

Humidity

Physical Specifications

Characteristic Specification

Height x Width x Depth

CTSLLGULH110S1
CTSLLPULH100S1
CTSLLGECH220S1

Weight

CTSLLGULH110S1
CTSLLPULH100S1
CTSLLGECH220S1

Electrical Specifications

Input Characteristic Input Specification

Input Voltage

CTSLLGULH110S1
CTSLLPULH100S1
CTSLLGECH220S1

-40º F to 140º F (-40º C to 60º C)

5% to 95% noncondensing within enclosure

20” x 22” x 7.5” (51cm x 56 cm x 19 cm)
14” x 22” x 7.5” (36 cm x 56 cm x 19 cm)
20” x 22” x 7.5” (51cm x 56 cm x 19 cm)

20 lbs (9 kg)
16 lbs (7 kg)
20 lbs (9 kg)

120 Vac
120 Vac
220 Vac

2

Chapter 2 Installation

Only trained service personnel should install and maintain the power supply.

Prior to installation, utility line voltage must be routed to the enclosure. Local, state, federal and/or
National Electric Code (NEC) regulations regarding location, permits and electrical wiring must be
adhered to.

Do not operate the power supply where the temperature and humidity are outside the specified limits.
See Specifications in this manual.

Unpacking

Inspect the unit upon receipt. Notify the carrier if there is damage.

The packaging is recyclable; save it for reuse or dispose of it properly.

The package contains:

 the enclosure

 a temperature sensor

 SLLP models; wiring harness

 product documentation

Models Supported

Model Number Description

CTSLLGULH110S1 Enclosure, SLL-G, 120 Vac, SM Ready, UL

CTSLLPULH100S1 Enclosure, SLL-P, 120 Vac, SM Ready, UL

CTSLLGECH220S1 Enclosure, SLL-GEC, 230 Vac, SM Ready. CE

3