DRIVER INSTALLATION PROCEDURE
（１）
（２）
Execute the file you have downloaded
If you already have a previous
version installed in your PC,
select "Install a new instance
of this application" and click
NEXT.
（３）
Select "I accept…" and click NEXT.
（４）
Click NEXT to install in the
proposed default folder. To
manually select a folder of your
choice, click BROWSE.
（５）
Click INSTALL to start
the installation
（６）
Enter a check in the box
and validate with FINISH.
（７）
Click INSTALL
You're done!
VERIFYING THE PC SETTINGS
Connect AR-mini to your PC through USB
Click on START followed by CONTROL PANEL
Switch to classic view if you see a window
like in this example
Classic view
Double click on SYSTEM
Click on DEVICE
MANAGER in the
HARDWARE tab
Click the + mark to
extend "PORTS
(COM&LPT)"
Select the PORT
SETTINGS tab
Make sure the speed
is set to 9600 bits/sec
Double click "Silicon Labs CP210x USB to
UART Bridge!" (Only appears when PC-mini
is connected to the PC)
Select ADVANCED
Select the COM port number to which AR-mini
is connected (Usually COM1 or COM2).
This number might vary when you connect or
disconnect other USB devices to your PC.
Validate your choice with OK.
QUICK GUIDE to the AR-mini Programming Tool
QUICK GUIDE to the AR-mini Programming ToolQUICK GUIDE to the AR-mini Programming Tool
QUICK GUIDE to the AR-mini Programming Tool
MENU BAR
MENU BAR
MENU BARMENU BAR
SETTINGS
SETTINGS
SETTINGSSETTINGS
To modify settings of your AR-mini receiver
NNNNew
ew： Start a new job
ewew
OOOOpen
pen： Open previously saved job
penpen
SSSSave
ave： Save what you are doing to the same file
aveave
Save
Save AAAAssss： Save what you are doing to a new file
Save Save
PPPPrint
rint： Print your memory data
rintrint
EEEExxxxit
it： Exit this program
itit
RRRRead from Radio
ead from Radio ： Import data from AR-mini receiver
ead from Radioead from Radio
Program to Radio
Program to Radio ： Export data to AR-mini receiver
Program to RadioProgram to Radio
Port
Port： Select the port to which AR-mini is connected
PortPort
AAAAbbbbout
out： Programming Tool's version number
outout
MEMORY MANAGEMENT
MEMORY MANAGEMENT
MEMORY MANAGEMENTMEMORY MANAGEMENT
Memory channel
Click on the memory channel number you need to edit
To save all your entries
Examples of correct entries
Enter the frequency
If SET does not bring your to the previous screen, you entries are
incorrect or insufficient.
Up to 6 characters
Either AM, FM or WFM
Active or not depending on your
choice in TONE SELECT
Japanese version only
SEARCH BAND MEMORY
SEARCH BAND MEMORY
SEARCH BAND MEMORYSEARCH BAND MEMORY
Click on the memory line of your
choice to edit the content
Enter the desired LOW and UPPER
frequencies and validate with SET
ERASING MEMORY
ERASING MEMORY
ERASING MEMORYERASING MEMORY
Select the memory channel number
you wish to erase and click on CLEAR.
To erase all memory channels, click on
CLEAR ALL
Loading...