Anvil FTA0400-120 R01, FTA0400 R03, FTA2600 R03, FTA3400 R01, FTA0900 R01 Installation Operation And Care
...
NB:
REGISTER ON-LINE TODAY
Register your warranty on-line now at www.anvilworld.com
NO WEB ACCESS
If you do not have access to the web. Kindly register by completing
the warranty registration form and fax it to the anvil ofce in the
country of purchase.
Failure to do so will invalidate your warranty.
FLAT TOP GRILLER ELECTRIC
INSTALLATION OPERATION AND CARE OF
FLAT TOP GRILLER ELECTRIC
MODELS: FTA0400 R03/FTA0400-120 R01/FTA3400 R01
FTA4400 R04/FTA4400-120 R01/FTA2600 R03
FTA0600 R03/FTA1600 R02/FTA3600 R02
FTA0900 R01/FTA4600 R02
4-INS-FTA0400R03
LIMITED WARRANTY
All equipment which is sold under ANVIL trademark and used for
commercial purposes is warranted against defects in materials and
workmanship. The warranty runs for one year from the date of original installation and is for the benet of the original purchaser only.
All other Warranties ,expressed or implied , statutory or otherwise,
including without limitations any implied Warranty of Merchantability
or tness for purpose are excluded .The Seller shall in no event be
liable for direct,indirect or consequential damages in connection with
ANVIL commercial products.
The Sellers obligation under this Warranty is limited to the repair of defects without charge. Defective units must be taken or
shipped,transportation charges prepaid,to ANVIL.
This Warranty is not effective if damage occurs because of
accident,carelessness,improper installation,lack of proper setup,supervision when required or if the equipment is installed or
operated in any manner contrary to the installation and operating
instructions. In these cases,repairs will be made at a reasonable
cost. Work performed by unauthorized personnel or unauthorized
service agencies using non Anvil spares voids this Warranty.
GENERAL INSTALLATION AND OPERATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO
GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR
PROTECTING AGAINST LOSS FROM CONCEALED DAMAGE.
THE FORM FOR FILING SUCH A CLAIM WILL BE PROVIDED
BY THE CARRIER.
UNPACKING
Unpack the product and check for any damage incurred during
transit. This should be reported to the responsible carrier, railway or
postal authority, and a request for a damage report should be made.
1. Before using the griller, turn the knob to maximum temperature.
Allow the griller to burn in for +/-30 minutes. You will notice smoke
appearing due to the protective coatings burning in. This is normal.
2. After the burning in period has lapsed, turn the temperature con trol knob down to the desired operating temperature. Grease
plates generously with butter or oil.
3. Never allow excess fat or oil to build up as this will result in the
building up carbon on the plates. This can be removed with a
scraper or grill brick.
4. The griller is provided with adjustable feet to enable the slope of
the griller plate to be set towards the fat drain tray.
Part
No.
1 BODY ASSEMBLY
2 GRILLER THERMOSTAT
3 CONTROL PANEL FACIA
4 PILOT LIGHT
5 FACIA PANEL INSERT
6 CONTROL KNOB
7 GRILLER FAT TRAY
8 ANVIL AXIS LOGO
9 ELEMENT CLAMP
10 PROBE CLAMP
11 BOTTOM COVER
12 ELEMENT COVER
13 INSULATION PAD
14 GRILLER ELEMENT
15 FAT TRAY SHIELD
16 ADJUSTABLE FEET
17 3 PHASE CONNECTOR BLOCK
18 GRILLER TOP ASS EMBLY
Description
MODEL: 600mm FLAT TOP ELECTRIC GRILLER
MODEL CODE : FTA4600 R02
1 30
SPECIFIC INSTALLATION AND OPERATION INSTRUCTIONS
FTA 1600 – Egg and Bacon Griller
The griddle plate surface is divided into two halves, a at half that can
be thermostatically controlled to 300ºC (570ºF) and the other half,
which is a tank, constructed onto the griddle surface. The temperature
of the oil in the tank can be independently controlled via a thermostat
to between 60 - 190ºC (140ºF - 374ºF).
1. The unit is equipped with two pilot lights for either half, which will
go out when the desired temperature is reached.
2. The oil tank is suitable for frying eggs. The temperature should be
set at between 110ºC - 130ºC (230ºF-266ºF) depending on how
the eggs need to be fried.
3. Care should be taken not to set the temperature too high as this
causes ‘blackening’ of the eggs.
4. The unit has also been provided with a ball valve to allow for the
draining of the oil.
5. Do not overll the tank, as hot oil is extremely dangerous and can
cause severe burns.
EXPLODED DIAGRAM
FLAT TOP GRILLER 6kW 2 PHASE
FTA4600 R02
1
2
3
4
5
6
7 8
9
11
12
13
14
15
16
EXPLODED DIAGRAM
600mm 2 PHASE ELECTIC GRILLER
MODEL:FTA4600 R02
10
17
18
29 2
FTA 4400 – Egg Fryer
1. The Egg Fryer has a specially constructed tank tted into the griddle
plate surface.
2. The temperature of the oil can be thermostatically regulated between
60ºC - 190ºC (140ºF - 374ºF ).
The remainder of the instructions are as per the FTA 1600 griller
above.
FTA4600, FTA4600HK, FTA0900
1. FTA 4600, FTA4600 HK and FTA0900 grillers require a suitable single,
two or three phase connection back to a distribution board. Please
contact a qualied electrician for this installation. N.B. The FTA 4600
HK is tted with two power-cords for connecting to 230VAC single phase supply.
2. The 900mm griller (FTA 0900) is equipped with three thermostats.
For accurate temperature control of the three heating zones, whilst
the 600mm griller (FTA 4600) is tted with two thermostats for the
independent control of the two heating zones. The red pilots light will
go out when the desired temperature is reached in each section.
TIP : COOKING AT A HIGHER TEMPERATURE
WILL NOT REDUCE YOUR COOKING TIME !
IT WILL PRODUCE UNSATISFACTORY RESULTS.
1 BODY A SSEMBLY
2 THERMOSTAT
3 CONTROL PANEL FACIA
4 PILOT LIGHT
5 CONTROL KNOB
6 CONTROL PANEL INSERT
7 ANVIL AXIS LOGO
8 ELEMENT CLAMPING BRACKET
9 BOTTOM COVER
10 ELEMENT COVER
11 INSULATION PAD
12 ELEMENT
13 DRIP TRAY HOLDER
14 PERFORATED T RAY
15 ADJUSTABLE FEET
16 CABLE GRIP
17 POWER CORD
18 TERMINAL BLOCK
19 400MM EGG GRILLER TOP AS SEMBLY
20 1/4 BALL DRAIN VALVE
Description
MODEL: 400mm EGG GRILLER
MODEL CODE : FTA4400 R04
Part
N
o.
283
CLEAN THE STEEL PARTS WITH WATER AND SOAP.
AVOID THE USE OF DETERGENTS CONTAINING
ABRASIVE SUBSTANCES. ALWAYS RINSE WELL AND
DRY CAREFULLY AFTER CLEANING. DO NOT USE
PRODUCTS CONTAINING AGGRESSIVE CHEMICALS,
ACIDS OR CHLORINE AS THIS WILL INVALIDATE THE
WARRANTY
ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED
FROM THE MAIN SUPPLY BEFORE CLEANING
WARNING
Burn Hazard.
Do not touch hot food,liquid or heating surfaces
while equipment is heating or operating
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling
EXPLODED DIAGRAM
400mm EGG FRYER 2kW
FTA4400 R04
1
23
4
5
6
7
8
9
10
11
12
13
14
15
16
17181920
EXPLODED DIAGRAM
400mm EGG GRILLER
MODEL: FTA4400 R04
CLEANING
1. Always ensure that the unit is disconnected from the main power
supply before cleaning.
2. The unit should not be cleaned with a water jet or immersed in
water. Use only a damp cloth or sponge dipped in soapy water.
3. Always clean equipment thoroughly before rst use. However,
do not use chlorine or chloride – based products to clean the
unit. These may lead to corrosion and pitting and will result in
voiding the warranty on the unit.
4. Wipe off the unit with a dry cloth and wait at least half an hour
before re – connecting to the main power outlet.
27 4
Loading...