TABLE OF CONTENTS
Warranty Information 2
Service/Technical Assistance 2
Important Safety Information 3
Warnings 3
Specications 4
Dimensions – see page 4
Electrical Ratings / Cord & Plug Congurations – see page 4
Installation 5
Operation 5
User Mode 6
Manager Mode 6
Safety Features 6
Hi-Limit Control – see page 6
Purging buns from Toaster – see page 6
Fault Messages 6
Error Codes 6
Daily Cleaning 7
Replacing Belts (Quarterly) 7
Removing Belts – see page 7
Installing Belts – see page 7
Cleaning the Top Cooling Fan and Electrical Housing (Annually) 8
Limited Warranty 10
WARRANTY
INFORMATION
Please read the full text of the Limited
Warranty in this manual.
If the unit arrives damaged, contact
the carrier immediately and le a damage claim with them. Save all packing
materials when ling a claim. Freight
damage claims are the responsibility of
the purchaser and are not covered under
warranty.
The warranty does not extend to:
y Damages caused in shipment or
damage as result of improper use.
y Installation of electrical service.
y Normal maintenance as out-
lined in this manual.
y Malfunction resulting from im-
proper
maintenance.
y Damage caused by abuse or care-
less
handling.
y Damage from moisture into electri-
cal
components.
y Damage from tampering with,
removal of, or changing any
preset control or safety device.
SERVICE/TECHNICAL
ASSISTANCE
If you experience any problems with the
installation or operation of your unit,
contact your local Roundup Authorized
Service Agency.
Fill in the information below and have it
handy when calling your Authorized Service Agency for assistance. The serial number is on the specication plate located on
the rear of the unit.
Purchased From
Date of Purchase
Model Number
Serial Number
Manufacturing Number
IMPORTANT
A.J. Antunes & Co. reserves the
right to change specifications and
product design without notice. Such
revisions do not entitle the buyer to
corresponding changes, improvements, additions or replacements
for previously purchased equip-
ment.
IMPORTANT
Keep these instructions for future refer-
ence. If the unit changes ownership,
be sure this manual accompanies the
equipment.
Use only genuine Roundup replacement
parts in this unit. Use of replacement
parts other than those supplied by the
manufacturer will void the warranty. Your
Authorized Service Agency has been factory trained and has a complete supply of
parts for this unit.
Visit www.ajantunes.com or contact the
factory at 1-630-784-1000 to locate your
nearest Authorized Service Agency.
Refer to the service agency directory
packaged with your manual and ll in the
information below.
Authorized Service Agency
Name
Phone Number
Address
2
P/N 1011189 Rev. B 07/14
IMPORTANT SAFETY
INFORMATION
Use the following guidelines for safe operation of the unit.
y Read all instructions be-
fore using equipment.
y For your safety, the equipment is
furnished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.
y Install or locate the equipment only
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
y Do not operate this equipment if
it has a damaged cord or plug, if
it is not working properly, or if it
has been damaged or dropped.
y This equipment should be serviced
by qualied personnel only. Contact
your nearest Authorized Service
Agency for adjustment or repair.
y Do not block or cover any
openings on the unit.
y Do not immerse cord
or plug in water.
y Keep cord away from
heated surfaces.
y Do not allow cord to hang over
edge of table or counter.
y Turn the power o, unplug the
power cord, and allow unit to
cool down before performing any
service or maintenance on the unit.
NOTE: Turning o the power switch
does NOT turn o all power to
the unit.
y The equipment should be grounded
according to local electrical codes to
prevent the possibility of electrical shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating.
y All electrical connections must
be in accordance with local electrical codes and any
other applicable codes.
y Do not clean this appli-
ance with a water jet.
WARNINGS
Be advised of the following warnings
when operating and performing maintenance on this unit.
y If the supply cord is damaged, it
must be replaced by the manufacturer or its service agent or
a similarly qualied person
in order to avoid a hazard.
y Do not modify the power sup-
ply cord plug. if it does not t
the outlet, have a proper outlet
installed by a qualied electrician.
y Do not use an extension
cord with this appliance.
y Electrical ground is re-
quired on this appliance.
y Check with a qualied electrician if
you are in doubt as to whether the
appliance is properly grounded.
y If a chemical cleaner is used, be
sure it is safe to use on cast aluminum. Observe all precautions
and warnings on product label.
y Inspection, testing, and repair
of electrical equipment should
only be performed by qualied service personnel.
y Do not use a sanitizing solu-
tion or abrasive materials. The
use of these may cause damage
to the stainless steel nish.
y Chlorides or phosphates in clean-
ing agents (e.g. bleach, sanitizers,
degreasers or detergents) could
cause permanent damage to
stainless steel equipment. The
damage is usually in the form of
discoloration, dulling of metal
surface nish, pits, voids, holes, or
cracks. This damage is permanent
and not covered by warranty.
y The following tips are recom-
mended for maintenance of your
stainless steel equipment:
• Always use soft, damp cloth for
cleaning, rinse with clear water
and wipe dry. When required,
always rub in direction of metal
polish lines.
• Routine cleaning should be done
daily with soap, ammonia detergent, and water.
• Stains and spots should be
sponged using a vinegar solution.
• Finger marks and smears should
be rubbed o using soap and
water.
• Hard water spots should be removed using a vinegar solution.
P/N 1011189 Rev. B 07/14
3