
TABLE OF CONTENTS
INTRODUCTION…………………………………………………………………....1
FEATURES…………………………………………………………………………..1
SAFEGUARDS………………………………………………………………………2
GROUNDING/EARTHING………………………………………………………....2
OPERATION…………………………………………………………………………3
Charging....................................................................................................... 3
Applications .................................................................................................. 3
Three Stage Charging Methodology ............................................................ 4
LED Indications ............................................................................................ 5
LCD Indications............................................................................................ 6
DDM (DIAGNOSTIC/DISCHARGE MODULE)................................................ 7
To Operate The DDM................................................................................... 8
“AUTOCAL” Feature ....................................................................................9
OPERATION AS DC CAMERA SUPPLY FROM MAINS .............................10
FUSE TYPE/REPLACEMENT……………………………………………………11
FCC NOTICE……………………………………………………………………….11
WARRANTY………………………………………………………………………..12

INTRODUCTION
The DUAL 2722 is a simultaneous 2 position Interactive 2000 PowerCharger fast
charger with 70 watt DC camera power supply. It incorporates all of the Logic
Series circuits that are employed in every Anton/Bauer charger. The InterActive
charge programming provides all charge termination and protection routines for safe,
reliable, chemistry independent charging.
Like all Anton/Bauer chargers, everything is automatic. Once a battery is placed onto
the charger, it will automatically go into one of the Three Stage Charging modes.
The left side of the charger is dedicated to charging, while the right side operates
simultaneously as selected between charging or operating as a camera power supply.
FEATURES
- Two independent 70 Watt Power Supplies – one for charging or DC power, and one
exclusively for charging.
- Fast Charging. One hour with most batteries (approximately 2 hours with HyTRON
series and 3 hours with Dionic batteries).
- Multifunction LCD displays critical battery and charger data automatically.
- Regulated DC power supply output for camera operation from AC mains, eliminating the
need for a separate bulky power supply.
- Wide range mains input compatibility (90-250 VAC 50-60 Hz) automatically adapts to
any mains source worldwide.
- Six (6) Independent Charge Termination Systems.
- Lightweight (2.75lbs.)
- Slim, ultra-lightweight design for easy portability.
- Serial output port for printer and PC interface.
1

SAFEGUARDS
Power Sources: This unit was designed to operate at mains voltages from
90 to 264 Volts AC, 50-60 Hz.
Risk of Electrical Shock: Refer servicing to qualified service personnel.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
GROUNDING/EARTHING
IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED.
To ensure safe operation, the three pin plug supplied must be inserted only into a
standard three-pin power point which is effectively grounded through the normal
household wiring. Extension cords used with the equipment must be three-conductor
and be correctly wired to provide connection to earth ground. Improperly wired
extension cords are a dangerous electrical hazard.
The fact that the equipment operates satisfactorily does not imply that the power point is
properly grounded and that the installation is completely safe. If any doubt exists about
the correct grounding of the power point, consult a qualified electrician.
IMPORTANT: The wires in this mains lead are colored in accordance with the
following code:
Green and yellow Earth
Blue Neutral
Brown Live
2