INSTALLATION INSTRUCTIONS
FOR OPTION 1 RACK MOUNT KIT
(MODEL 360 ANALYZER AND TEST SET)
Instructions for removing the instrument side
panels and installing the rack mount side panels
(Figure 1) are given below.
@@
Figure 1.
Option 1 Rack Mount Kit
c. Slide the right mounting bracket into the side
cover channels until the flange meets the rear
panel.
Corner Brackets (4)
Analyzer
,
1“
Test Set
(
Corner Brackets (4)
Figure 2.
Model 360 Analyzer and Test Set, Rear
1. Install the right mounting bracket (Figure 1,
Index 1) as follows:
a. Remove the top and bottom corner brackets
from the rear panel of the analyzer/test set
(Figure 2).
b. Slide the side cover out (this part maybe dis-
carded).
d. Reattach the two corner brackets.
2. Install the left mounting bracked (Figure 1, Index
2) in the same manner as described for the right
mounting bracket.
NOTE
A package of hardware is included with
the Rack Mount Kit. Use as needed to
mount the equipment into an instrument rack.
P/N 10910-00013
REVISION: A
PRINTED: NOVEMBER 1987
COPYRIGHT 19S7 WILTRON CO.
Loading...