
Vacuum Cleaner
User Manual
Model no.: VC8273-L-9
PLEASE READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE

WARNING: Do not recharge non-rechargeable batteries.
WARNING: Before charging the product, please make sure your hands are dry.
WARNING: Please use the charger we supplied with the appliance. Other chargers
may cause electrical failure and/or fire.
FOR HOUSEHOLD USE ONLY.
This appliance should only be used for domestic cleaning, and must only be used
indoors, as described in this user guide.
1. Always switch off and remove the charger from the socket before cleaning the
appliance or any maintenance task.
2. This appliance is not intended for used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliances by a person responsible for their safety.
3. Children should be supervised to ensure that they do not play with the
appliance.
4. If the power cord is damaged, it must be replaced by a qualified electrician in
order to avoid hazard or the appliance must be disposed of.
5. Use only the original charger supplied with the appliance.
6. Check that your supply voltage is the same as that stated on the charger.
7. When charging the appliance, the power switch must be off.
8. Never charge the batteries in temperatures above 37°C or below 0°C.
9. It is normal for the charger to become warm to the touch when charging.
10. Use only attachments provided.
11. Static electricity: some carpets can cause a small build up of static electricity. Any
static discharge is not hazardous to health.
12. Do not use your appliance outdoors or expose to weather.
13. Do not spray with or pick up flammable liquids, cleaning fluids, aerosols or their
vapors.
14. Do not continue to use your appliance or charger if it appears faulty.
15. Do not leave the appliance unattended when in use.
16. Never use the appliance without the filters in place!
17. Check the filters are inserted correctly!
18. Do empty the Dust Cup regularly for optimal operation of the vacuum.
19. Do not replace the batteries with non-rechargeable batteries.
20. The vacuum must use only with provided battery charger:
WJA-Y081750400W.

End of Product Life Battery Disposal
If the cleaner is to be disposed of, the batteries should be removed.
The battery is to be disposed safely.
Used batteries should be taken to a recycling station and not disposed of with
household waste. To remove the batteries, please proceed according to the following
inspections:
IMPORTATNT! Always fully discharge the batteries before removal and ensure
the charger is unplugged.
1. Run the vacuum cleaner until it stops to fully discharge the batteries.
2. Remove the ergonomic handle and the screws, in the main body to open the
cleaner.
3. Remove the motor housing and disconnect the cables.
4. Remove the batteries from the housing.
Note: Contact your local council waste disposal service for proper disposal facilities

Charging/ Power indicator
Plug the charger into the wall outlet, ensure the voltage of the electricity supply is same as that
indicated on the rating label of battery charger. When charging is completed, pull out the battery
charger from the socket.
For first use, charge your vacuum cleaner for 6hrs and then completely discharge it. After first use
the normal charging time is 5Hrs.
The indicator light will flash during charging, it turns to GREEN steady light when fully charged.
When the battery level is high, indication lights will remain GREEN, it turns RED when battery level
is low. Indicator will flash for around 20 seconds before the vacuum cleaner turn off automatically.
THE PRODUCT NEEDS TO BE CHARGED PERIODICALLY (2 or 3 TIMES A MONTH) TO
ENSURE OPTIMUM BATTTERY LIFE, EVEN IF YOU HAVE NO INTENTION OF USING IT FOR
A LONG TIME.

ASSEMBLY
A crevice tool is built into the nozzle
and can be flipped-down for dry
vacuum use.
Fold the crevice tool and attach the
rubber wiper provided for wet suction.
Push the rubber wiper on to the nozzle,
ensuring it is tightly fixed.
A brush is provided for general
cleaning.
Flip-down the crevice tool, then push
the brush attachment to crevice tool.
Ensure it is tightly fixed.
IMPORTANT! For Dry and Wet vacuum, the cloth filter must always be used
when operating the handheld vacuum cleaner.

USING THE VACUUM
Turn on the vacuum cleaner by sliding
the On/Off switch forward.
(i.e. “O” = OFF, “I” = ON).
To stop, slide the switch back.
Return the product to the charging
base after each use.
Press the dust cup release button and
pull out the dust cup
Pull out the filter.
MAINTENANCE

Wash the filter and dust cup under
rinsing water.
Leave to dry for 24 hours.
Make sure filter and dust bin are dried
thoroughly before fitting them back to
the unit.
IMPORTART! Filters must be
cleaned regularly for best suction
performance and to prevent
over-heating and damaging the
vacuum cleaner

STORAGE
Wall Mount
There is a wall mount accessory
supplied with screws and wall
plugs.
To install the wall mount bracket,
position it on the wall at a suitable
height.
Mark the two screw holes through
onto the wall. Using a suitable drill
(wood drill bit for timber wall, or
masonry drill bit for brick /
concrete walls, drill three holes
Ø6mm and 35 - 40mm deep.
Insert the plastic wall plugs into
each hole and gently hammer in
until they are flush with the wall,
place the hanging mount over the
holes then insert the screws and
tighten up. Do Not Overtighten.
Insert the DC jack through the
bottom hole of wall mount bracket,
twist in 90deg to hold it at base
Seat the handheld vacuum on the
wall mount bracket, the vacuum
can start charging in this position.

TROUBLESHOOTING
The vacuum cleaner does not
switch on
1. The power switch on unit is
OFF.
2. Bad contact to mains power
socket/ charger jack
1. Slide the power switch
forward.
2. Check connection and see
if battery is fully charged
1. Brush head not correctly
fitted.
2. The dust cup is full
3. The filters are blocked
1. Check brush head had
connected to main unit
2. Empty dust cup
3. Wash the filter
WJA-Y081750400W
Input:100-240V 50-60Hz 16W;
Output 17.5V d.c. 400mA
SPECIFICATION

12 MONTH WARRANTY
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects in materials and
workmanship for the period stated above, from the date of purchase, provided that the
product is used in accordance with accompanying recommendations or instructions where
provided. This warranty is in addition to your rights under the Australian Consumer Law.
Kmart will provide you with your choice of a refund, repair or exchange (where possible)
for this product if it becomes defective within the warranty period. Kmart will bear the
reasonable expense of claiming the warranty. This warranty will no longer apply where
the defect is a result of alteration, accident, misuse, abuse or neglect.
Please retain your receipt as proof of purchase and contact our Customer Service Centre
on 1800 124 125 (Australia) or 0800 945 995 (New Zealand) or alternatively, via Customer
Help at Kmart.com.au for any difficulties with your product. Warranty claims and claims
for expense incurred in returning this product can be addressed to our Customer Service
Centre at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
For New Zealand customers, this warranty is in addition to statutory rights observed under
New Zealand legislation.