Anko KB-950RVE3 User Manual

Cordless Steam Iron

User Manual

Model: KB-950RVE3

IMPORTANT SAFETY INSTRUCTIONS

Read this user manual carefully before first
use and save it for future reference.

 This appliance is not intended for use by

persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge, unless
they have been given supervision or
instructions concerning use of the appliance
by a person responsible for their safety.

 Children should be supervised to ensure

that they do not play with the appliance.

 Cleaning and user maintenance shall not be

made by children without supervision.

 This product has been designed for

domestic use only. In case of any
commercial use, inappropriate use or
failure to comply with the instructions, the
manufacturer is not responsible, and the
guarantee will not apply.

 Before connecting your appliance, check if

the mains voltage is the same as the voltage
indicated on your appliance and that the
power outlet has an earth connection. If
unsure check with an electrician.

 Before each use ensue that the electric cord

or any other parts on the iron is not
damaged.

 Keep the iron and its cord out of reach of

children when it is connected to mains
power or cooling down.

 Never direct the steam towards persons or

animals. Never direct the steam jet towards
any other electrical or/and electronic
appliances.

 The iron is not to be used if it has been

dropped, if there are visible signs of
damage or if it is leaking water.

 If the appliance shows evidence of damage,

malfunction, water leaks or other
abnormality, DO NOT use.

 Always make sure the appliance is switched

off, unplugged and cooled down before
cleaning.

 IMPORTANT! The iron must not be left

unattended while it is connected to mains
power and before it has cooled down.

 Do not unplug the appliance by pulling on

the cord or on the appliance.

 Never immerse the iron, the stand, the

cable or cord plug in water. Never wash
them under a water tap.

 The soleplate of the iron can become

extremely hot and may cause burns if
touched. Do not allow the supply cord to
come in contact with the soleplate.

 CAUTION! For electrical safety, if the

supply cord is damaged, it must be
replaced by qualified electrical person only
to avoid a hazard or the product must be
disposed.

 Disconnect from mains power when filling

the reservoir in the iron with water.

 The iron must be used and rested on a flat,

stable surface.

 Always place and operate the iron on a flat,

solid, clean and dry surface. When placing
the iron on its stand, ensure that the
surface on which the stand is placed is
stable.

 For additional protection, this appliance

should be connected to a household
residual current device (RCD/safety switch)
with a rating of no more than 30mA. If
unsure consult your electrician for advice.

BEFORE FIRST USE

Unpack the appliance and check if all parts are there and undamaged. Should this not be the case,
return the product to Kmart for replacement.
The packaging contains:

 One steam iron
 One charging base
 One filler cup

Clean all parts before first use. See Cleaning and Maintenance
Heat up the iron to its maximum temperature and iron over a piece of damp cloth for several
minutes. This will burn-off any manufacturing residue from the iron. Smoke and odour may occur
for a short period during this process, which is normal.

FEATURES

Your iron has an Anti-Drip system, Anti-Scales system and Auto-Off function.

Anti-Drip system: This is to prevent water from escaping from the soleplate when the iron is cold.
During use, the anti-drip system may emit a loud ‘clicking’ sound, particularly when heating up
or cooling down. This is normal and indicates that the system is functioning correctly.

Anti-Scale system: The built-in anti-scale cartridge is designed to reduce the build-up of lime scale

in the iron which occurs during steam ironing. The anti-scale cartridge is designed to prolong the
working life of your iron. The anti-calc cartridge is an integral part of the water tank and does not
need to be replaced.

Auto-Off function: Automatically switches ‘off’ the steam iron if it has not been moved for a while.
Approx. after 8 mins., if the iron is left resting on the stand

PARTS

1

Soleplate

8

Indicator lamp

2

Spray nozzle

9

Handle

3

Water Filling inlet

10

Connecting coupler

4

Self-clean button

11

Power base

5

Steam control button

12

Power indicator

6

Steam shot button

13

Temperature dial

7

Spray button

14

Water tank