Anko KB-932E3 User Manual

Steam Iron

User Manual

Model: KB-932E3

IMPORTANT SAFETY INSTRUCTIONS

Read this user manual carefully before first use and
save it for future reference.

• This appliance is not intended for use by persons

(including children) with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge, unless they have been given supervision
or instructions concerning use of the appliance by a
person responsible for their safety.

• Children should be supervised to ensure that they do

not play with the appliance.

• Cleaning and user maintenance shall not be made by

children without supervision.

• This product has been designed for domestic use

only. In case of any commercial use, inappropriate
use or failure to comply with the instructions, the
manufacturer is not responsible, and the guarantee
will not apply.

• Before connecting your appliance, check if the mains

voltage is the same as the voltage indicated on your
appliance and that the power outlet has an earth
connection. If unsure check with an electrician.

• Ensure before each use that the supply cord or any

other parts are not damaged.

• Keep the iron and its cord out of reach of children

when connected to mains power or cooling down.

• Never direct the steam towards persons or animals.

Never direct the steam jet towards any other
electrical or/and electronic appliances.

• DO NOT use the iron if it has been dropped, if there

are visible signs of damage, malfunction or if it is
leaking water.

• Always make sure the appliance is switched off,

unplugged and cooled down before doing any
maintenance work.

• IMPORTANT! This iron must not be left unattended

while it is connected to mains power and before it
has cooled down. The soleplate of the iron can
become extremely hot and may cause burns if
touched.

• Do not unplug the appliance by pulling on the cord

or on the appliance.

• Never immerse the iron, the stand, the power cord

or the plug in water. Never hold them under a water
tap.

• Do not allow the supply cord to come in contact with

the soleplate when the iron is hot.

• If the supply cord is damaged, it must be replaced by

qualified electrical person only or the product must
be disposed.

• Disconnect from mains power when filling the

reservoir in the iron with water.

• The iron must be used and rested on a flat, stable

surface.

• Always place and operate the iron on a flat, solid,

clean and dry surface. When placing the iron on its
stand, ensure that the surface on which the stand is
placed is stable.

• For additional protection, this appliance should be

connected to a household residual current device
(safety switch) with a rating of no more than 30mA.
If unsure consult an electrician for advice.