anko BL9005-CB User Manual

Blender

BL9005-CB

User Manual

PLEASE READ AND SAVE THESE

INSTRUCTIONS FOR FUTURE REFERENCE

1

IMPORTANT SAFEGUARDS

When using the electrical appliance, the below basic safety precautions should be
followed:

1. Read all instructions.

2. Before using check that the voltage power corresponds to the one shown on the
appliance nameplate.

3. Do not let cord hang over edge of table or counter.

4. Do not leave the product unattended while it is in use, especially when children
are present.

5. Do not immerse power cord, plug, or product in water or other liquids. If the
product falls into water, disconnect from mains power outlet immediately. Do not
touch or reach into the water.

6. Do not place on or near a hot gas or electric burner, or in a heated oven.

7. Never operate this product if it has a damaged Power Cord or plug, is not working
properly, has been dropped or damaged, or if the Base has been exposed to water or
other liquids. Do not attempt to examine or repair this product yourself. Any repairs
to the product should be carried out by a qualified electrical person only or the
product must be disposed.

8. Do not operate any appliance with a damage cord or plug or after the appliance
malfunction or has been damaged in any manner.

9. If the supply cord is damaged, it must be replaced by qualified electrical person in
order to avoid a hazard or the product must be disposed of.

10. This appliance is not intended for used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of
the appliances by a person responsible for their safety.

11. Children should be supervised to ensure that they do not play with the appliance.

12. Avoid contacting moving parts.

13. Blades are sharp, so handle carefully.

14. The use of attachment, including jar, jar lid, not recommended or sold by
manufacturer may cause fire, electric shock or injury.

15. The appliance cannot be used for blending hard and dry substance, otherwise the
blade could be blunted or damaged.

16. Unplug from mains power outlet when not in use, before putting on or taking off
parts, and before cleaning.

2

17. To protect against risk of electrical shock do not put motor unit or power cord in
water or other liquid.

18. Do not use outdoors.

19. Keep hands and utensils out of container while blending to reduce the risk of
severe injury to persons or damage to the blender. A scraper may be used but must be
used only when the blender is not running.

20. To reduce the risk of injury, never place cutter-assembly blades on base without
jar properly attached.

21. Always operate blender with the cover in place.

22. Warning: never use hot liquids or run the appliance empty.

23. Be care of potential injury from misuse.

24. Care shall be taken when handling the sharp cutting blades, emptying the bowl
and during cleaning.

25. Always disconnect the appliance from the supply if it is left unattended and before
assembling, disassembling or cleaning.

26. Switch off the appliance and disconnect from mains power before changing
accessories or approaching parts that move in use.

27. This appliance is intended to be used in household and similar applications such
as:

– Staff kitchen areas in shops, offices and other working environments;
– Farmhouses;
– By clients in hotels, motels and other residential type environments;
– Bed and breakfast type environments.

Model: BL9005-CB

IMPORTANT!
Do not blend hot liquids.
Be careful if hot liquid is poured into the blender, it can be ejected out of the

appliance due to sudden steaming.
To prevent damage to the electric motor, the maximum operating time is 30

seconds. Allow it to rest for 1 minute before using it again. After 5 cycles of
operation, allow the blender to cool down to room temperature for approximate
30 minutes before using it again.

Save these instructions