Andrew VHLP2-15-IT1B, VHLP1-13-IT1B, VHLP2-13-IT1B, VHLP1-15-IT1B, VHLP1-18-IT1B Installation Instructions Manual

Installation Instructions

0.3m(1ft) & 0.6m(2ft)

Bulletin 102217

ValuLine

In order to change polarization of single polarized antennas
from vertical (factory pre-set) to horizontal. It will be
necessary to rotate the output transition. This is done by
loosening the attachment screws until transition can rotate
freely, rotate the transition 90 deg. clockwise and re­tightening the attachment screws.

The installation, maintenance, or removal of antenna
systems requires qualified, experienced personnel.
Andrew installation instructions have been written for
such personnel. Antenna systems should be inspected

once a year by qualified personnel to verify proper
installation, maintenance, and condition of equipment.

Andrew disclaims any liability or responsibility for the
results of improper or unsafe installation practices.



Antennas Siemens IT1B

Description

Notice

1

Note:-

Remove protective blanking plate
and hardware prior to fitting radio.
(Plate hardware to be retained if
radio is required to be remote
mounted)

2

Change of Polarization method

Timing mark on

transition with timing

mark on mounting ring

(Vertical Polirization)

Transition hub

Loosen screws (6 places) until

transition can rotate freely
then rotate transition hub 90 deg.
untill it "locates" in timing recess.

1ft version of Antenna shown

Vertically Polarized Application

When located, re-tighten to a

torque of 5Nm (3.69 lb-ft)

Horizontally Polarized Application

Timing mark on

transition to line up

with timing mark on

mounting ring

(Horizontal

Polarization)

Declaration of Conformity

The products listed below are in conformity with the following relevant regulations and standards:

1999/5/EC Directive of the European parliament and the council of March 1999 on radio equipment
and telecommunications terminal equipment and the mutual recognition of their conformity

EN 300 833 Fixed Radio Systems; Point to Point Antennas; Antennas for point-to-point fixed radio
systems operating in the frequency band 3 GHz to 60 GHz and with the following technical specification
according to ETSI EN 300 833:

Product Description Freq. Freq. RPE Gain XPD

range Band [GHz] Class Cat. Cat.

VHLP2-10 0.6m Antenna, 10GHz, High Perf. Low Profile 1 10.5  10.7 3 2 1

VHLP1-13 0.6m Antenna, 13GHz, High Perf. Low Profile 1 12.7  13.25 2 2 1

VHLP2-13 0.6m Antenna, 13GHz, High Perf. Low Profile 1 12.7  13.25 3 2 1

VHLP1-15 0.3m Antenna, 15GHz, High Perf. Low Profile 2 14.25 -15.35 2 2 1

VHLP2-15 0.6m Antenna, 15GHz, High Perf. Low Profile 2 14.25 -15.35 3 2 1

VHLP1-18 0.3m Antenna, 18GHz, High Perf. Low Profile 2 17.7  19.7 2 2 1

VHLP2-18 0.6m Antenna, 18GHz, High Perf. Low Profile 2 17.7  19.7 3 2 1

VHLP1-23 0.3m Antenna, 23GHz, High Perf. Low Profile 3 21.2  23.6 3 2 1

VHLP2-23 0.6m Antenna, 23GHz, High Perf. Low Profile 3 21.2  23.6 3 2 1

VHLP1-26 0.3m Antenna, 26GHz, High Perf. Low Profile 4 24.25  26.5 2 2 1

VHLP2-26 0.6m Antenna, 26GHz, High Perf. Low Profile 4 24.25  26.5 2 2 1

VHLP1-38 0.3m Antenna, 38GHz, High Perf. Low Profile 5 37.0  40.0 2 horiz 2 1

2&3 ver 2 1

VHLP2-38 0.6m Antenna, 38GHz, High Perf. Low Profile 5 37.0  40.0 2 horiz 2 1

2&3 ver 2 1

Andrew Corporation

10500 West 153rd Street
Orland Park, IL U.S. A. 60462

Telephone: [phone]
FAX (U.S.A.): 1-800/349-5444
TELEX: 25-3897

Customer Service, 24 hours: U.S.A.  Canada  Mexico: 1-800/255-1479
U.K.: 0800 250055  Republic of Ireland: 1 800 535358
Other Europe: [phone]

Copyright © 1993 by Andrew Corporation

Printed in E.C. Jan04