Amprobe INSP-3 Specifications
No hassle
warranty
No waiting.
No shipping
charges.
Our commitment to
high-quality products
and customer service
is demonstrated by
our industry exclusive
“No Hassle” warranty.
In the unlikely event
that an Amprobe Test
Tool requires warranty
service, any of our
local dealers are
authorized to replace
it, on the spot.
(note: $500 MSLP limit)
Data Sheet
INSP-3
Wiring Inspector Tester
The INSP-3, wiring inspector is a rugged tester designed to verify
building wiring compliance to electrical code, especially voltage
drop under load. Identify issues with splices, connections and
conductor quality, crucial to safety and performance of the
electrical system.
n Testing efficiency - relevant test data (voltage, voltage
drop, hot and neutral voltage drop, voltage with load,
ground impedance) is presented on a single large display to
save operator time - no scrolling or switching screens needed
n Verifies if wiring is tested for load carrying ability that it
meets electrical code recommendations for voltage drop
under load
n Meter detects faulty wiring in need of repair without
removing outlets cover plates, or panel covers:
n Faulty splices and connections
n Incorrect wiring
n Undersized wiring
n Faulty GFCIs,
n Faulty or incorrectly wired AFCIs
n Incorrect line voltage
n Poor ground quality
n User selectable 0, 10,15 and 20 amps loads to verify
performance of the electrical system
n Incorrect wiring or voltage drop test failure is clearly indicated
by flashing screen
n Will not trip circuit breakers or blow fuses during the test
n Tests GFCI and AFCI operations
n Check ground quality for safety and ability to support
sensitive electronic equipment
n Measure fault currents
n Save money and time by eliminating guess work
Amprobe® Test Tools
www.Amprobe.com
INSP-3 Wiring Inspector Tester
Specifications
Load Constant 0, 10, 15 or 20 AMP simulation regardless of line voltage
Operating Voltage 95-140 VAC
Battery 9V Alkaline
Fuse 1/2 Amp, 125 Volt
GFI Trip 6.0 mA nominal to trip GFI, 30 mA to trip RCD
AFCI Trip Up to 8, 120 AMP pulses within 1/2 second period
Operating Temperature 32ºF to 120ºF (0º - 50ºC)
Accuracy +/-2%, +/- 2 digits
Included Accessories
Power Cord
9V Alkaline Battery (Installed)
Users Manual
Carrying Case
Data Sheet
Amprobe® Test Tools
website: www.Amprobe.com
email: info@amprobe.com
Everett, WA 98203
Tel: 877-AMPROBE
Amprobe® Test Tools Europe
In den Engematten 14
79286 Glottertal, Germany
Tel.: +49 (0) 7684 8009 - 0
Amprobe® Test Tools
©2010 Amprobe Test Tools . All righ ts reserved.
7/2010 INSP-3_ DS Rev A
www.Amprobe.com
Loading...