Ameriphone SR95 User Manual

©AMERIPHONE products are manufactured by Walker,
A Division of Plantronics, Inc.
12082 Western Avenue, Garden Grove, CA 92841
[phone] VOICE • [phone] TTY/TDD
[phone] FAX
email: [e-mail]
website: www.ameriphone.com

®

E
N
G

L

I

S
H

E
S
P
A
Ñ
O

L

F

R
A
N

Ç
A

I

S

SR200 M52002 A 4/03

SUPER PHONE RINGER

MODEL SR-200 & SR-95

Users’ Guide

∆

®

Operation . . . . . . . . . . . . . .3

Safety Information . . . . . . . . .4

Installation . . . . . . . . . . . . .15

Warranty . . . . . . . . . . . . . .18

Your Satisfaction . . . . . . . . .19

Regulatory Compliance . . . .20

Table Of Contents

Operation

1. Select the ring pattern.

2. Adjust ringing tone.

3. Adjust the volume.
(When it is turned to OFF,
light will still flash when
phone rings.)

E
N
G

L

I

S
H

xxx3

Important Safety Instructions

When using your SR-200 Super Phone Ringer,
basic safety precautions should always be
followed to reduce the risk of fire, electric shock
and persons including the following:

1. Read and understand all instructions.

2. Follow all warnings and instruction
marked on the SR-200 Super Phone Ringer.

3. Do not use this SR-200 Super Phone
Ringer near a bathtub, wash basin,
kitchen sink or laundry tub, in a wet
basement, near a swimming pool or
anywhere else there is water.

4. Avoid using a telephone (other than a
cordless type) during a storm. There
may be a remote risk of electrical
shock from lightning.

5. Do not use the telephone to report a
gas leak in the vicinity of the leak.

6. Unplug the SR-200 Super Phone Ringer
from the wall outlets before cleaning. Do

4xxx

not use liquid cleaners or aerosol
cleaners on the product. Use a damp
cloth for cleaning.

7. Place this ringer on a stable surface.
Serious damage and/or injury may
result if the telephone falls.

8. Do not cover the slots and openings
on this product. It should never be
placed near or over a radiator or heat
register. It should not be placed in a
built-in installation unless proper
ventilation is provided.

9. Operate this product using the
electrical voltage as stated on the base
unit or the owner’s manual. If you are
not sure of the voltage in your home,
consult your dealer or local power
company.

10. Do not place anything on the power
cord. Install the product where no
one will step or trip on the cord.

11. Do not overload wall outlets or extension
cords as this can increase the risk of fire

E
N
G

L

I

S
H

xxx5

or electrical shock.

12. Never push any objects through the
slots in the product. They can touch
dangerous voltage points or short out
parts that could result in a risk of fire
or electrical shock. Never spill liquid of
any kind on the product.

13. To reduce the risk of electrical shock, do
not take this product apart. Opening or
removing covers may expose you to
dangerous voltages or other risks.
Incorrect reassembly can cause electric
shock when the product is subsequently
used.

14. Unplug this product from the wall outlets
and refer servicing to the manufacturer
under the following conditions:

A.When the power supply cord or plug

is frayed or damaged.

B. If liquid has been spilled into the

product.

C.If the product has been exposed to

6xxx