American Standard Cadet 2998.012 Specification Sheet

CADET™ RIGHT HEIGHT™ ELONGATED TOILET

❑ 2998.012

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• 16-1/2" rim height for accessible applications

• Elongated siphon action jetted bowl

• AquaForce  ushing technology

• Fully glazed 2" trapway

• Close-coupled tank with raised lip detail on tank cover

• Color-matched trip lever

• Speed Connect™ tank/bowl coupling system

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory  ush tested

❑ 3417.016 Bowl

❑ 4112.016 Tank

❑ 2998.164 with Slotted Rim for Bedpan holding

❑ 3417.164 Bowl ❑ 4112.016 Tank

Alternate Tank Con gurations Available:

❑ 4112.300 Tank complete with chrome all metal

trip lever

❑ 4112.500 Tank complete with Aquagard liner ❑ 4112.60 0 Tank complete with tank cover

locking device

❑ 4112.700 Tank complete with Aquagard liner and

tank cover locking device

❑ 4112.800 Tank complete with trip lever located

on right side

❑ 4112.900 Tank complete with tank cover device

and trip lever located on right side

Nominal Dimensions: 756 x 495 x 813mm (29-3/4" x 19-1/2" x 32")

Fixture only, seat and supply by others

Compliance Certi cations Meets or Exceeds the Following Speci cations:

• ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Speci ed:

❏ Color: ❏ Seat: American Standard #5324.019 “Rise and

Shine" solid plastic closed front, seat with cover. ❏ Seat: American Standard #5311.012 “Laurel" molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with stop:

CADET™ RIGHT HEIGHT™

ELONGATED TOILET

VITREOUS CHINA

FINISHED WALL

756mm

19mm ± 6mm (3/4 ± 1/4)

225mm (8-7/8)

83mm

(3-1/4)

178mm

(7)

305mm

(12)

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of  xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

(29-3/4)

470mm

(18-1/2)

C/L OF SEAT POST HOLES 140mm (5-1/2 CENTERS)

16mm

(5/8)

311mm

(12-1/4)

C/L OF OUTLET

419mm

(16-1/2)

FINISHED FLOOR

SUPPLY

REQ'D

254mm

(10)

152mm

495mm

(19-1/2)

813mm

(32)

375mm (14-3/4)

(6)

235mm

(9-1/4)

K53

Revised 5/05