American Standard 3167.016, 2627.014 User Manual

FIN ISHE D WALL

19m m ± 6mm (1 ± 1/ 4)

387 mm

(15 -1/4 )

FIN ISHE D FLO OR

305 mm

(12 )

721 mm

(28 -3/8 )

C/L OF OUTLET

83m m

(3- 1/4)

216 mm (8- 1/2)

419 mm

(16 -1/2 )

C/L OF SEAT P OST HO LES 140 mm ( 5-1/2 CENTER S)

381 mm

(15 )

273mm

(10-3/4)

16m m

(5/ 8)

844 mm

(33 -1/4 )

492 mm

(19 -3/8 )

SUP PLY

REQ 'D

286 mm

(11 -1/4 )

152 mm

(6)

254 mm

(10 )

356 mm

(14 )

OAKMONT CHAMPION® 4 ROUND FRONT TOILET

❑ 2627.014

• Vitreous china

• EverClean™ anti-microbial surface which inhibits the growth of stain and odor causing

bacteria, mold, and mildew

• Low-consumption (6.0 Lpf/1.6 gpf)

• Features Champion®4 Flushing System performance platform

• 4" non-adjustable, piston action Accelerator™ ush valve

• Round front siphon action jetted bowl

• 2-3/8" fully-glazed trapway

• Speed Connect™ tank/bowl coupling system

• Chrome-plated trip lever

• Sweeping pier on bowl

• 100% factory ush tested

• 2 bolt caps

• 10 year warranty

❑ 3167.016 Round Front Bowl ❑ 4272.014 Tank

OAKMONT CHAMPION® 4

ROUND FRONT TOILET

VITREOUS CHINA

Nominal Dimensions:

721 x 492 x 844mm (28-3/8" x 19-3/8" x 33-1/4")

Fixture only, seat and supply by others

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

• Los Angeles Department of Water and Power Supplementary Purchase Specication for Non-Adjustability - July, 2003 revision

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black ❏ Seat: (please specify color)

❏ Champion® Slow Close Round Front #5330.010 ❏ Rise & Shine Round Front #5322.011 ❏ Laurel Round Front #5308.014 ❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K20

Revised 07/07