American Standard 2447.000 User Manual
SPACESAVER CADET® 3 ELONGATED
FINISHED WALL
FINISHED
FLOOR
C/L OF OUTLET
191mm
(7-1/2)
716mm
(28-1/4)
15mm
(5/8)
102mm
(4)
470mm
(18-1/2)
381mm
(15)
305mm
(12)
296mm
(11-5/8)
267mm
(10-1/2)
C/L OF SEAT POST
HOLES 140mm
(5-1/2 CENTERS)
SUPPLY
AS
REQ'D.
439mm
(17-1/4)
733mm
(28-7/8)
*203mm
(8)
355mm
(14)
*152mm
(6)
236mm
(9-5/16)
COMPLETE TOILET
❑ 2447.000
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• Space saving compact design - Elongated bowl
ts in the same space as a round front toilet
• 12" (305mm) Rough-in
• EverClean® surface inhibits the growth of stain
and odor causing bacteria, mold and mildew on
the surface
• Featuring the Cadet® 3 Flushing System
• Elongated siphon action jetted bowl with
2-1/8" trapway
• Internal trapway area fully glazed
• Generous 8" x 9" water surface area
• Close coupled tank with at tank cover for
superior storage
• Oversized 3" Flush Valve with Chemical
Resistant Flapper
• Speed Connect® tank to bowl coupling system
• Sanitary dam on bowl with four point
tank stabilization
• 2 color match bolt caps
• Chrome Trip Lever
• Color matched solid plastic seat with cover
• Wax ring gasket with closet bolts
• 100% factory ush tested
• 5 year warranty
SPACESAVER CADET® 3 ELONGATED
COMPLETE TOILET
VITREOUS CHINA
Nominal Dimensions:
718 x 438 x 733mm
(28-1/4" x 17-1/4" x 28-7/8")
Compliance Certications Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specication for
Non-Adjustability
© 2008 AS America Inc.
To Be Specied:
❏ Color: ❏ White
❏ Supply with stop
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION
OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
DIMENSIONS SHOWN FOR LOCATION OF SUPPLY ARE SUGGESTED.
*
SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED
SEPARATELY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range
of tolerance established by ANSI Standard A112.19.2.
These measurements are subject to c hange or cancellation. No responsibility is
assumed for use of superseded or voided pages.
K99
Revised 2/08
Loading...