American Metal Ware BL-2P, BA-P, BL-3PW User Manual

INSTALLATION, OPERATION, AND SERVICE MANUAL

INSTALLATION INSTRUCTIONS

1) Place the decanter under brew basket, raise top evaporation cover and pour three decanters of water through the
top pour-in opening. Water should come through the brew basket as the third decanter of water drains out of the
pour-in basin.

2) Brewer is shipped with thermostat turned on, (full clockwise position). Plug brewer into a dedicated, grounded
120V/15A circuit.

3) Allow 10-15 minutes for water in tank to heat to brewing temperature. (Hot water may drip from brew basket on
initial thermal expansion of water in the tank). This will not occur thereafter.

4) After water has reached brewing temperature (thermostat will click off, heating noise will stop and green ready light
will be on) pour 1 decanter (60 oz.) of water through pour-in opening. More than 1 decanter of water will flow into
decanter below brew basket due to water expansion in tank. Machine in now ready to use.

5) Pour 1 decanter of water through pour-in opening to check for proper temperature setting with an accurate
thermometer. Take the temperature of this water at a point below the brew basket opening at the start of the brew
cycle and when the decanter is half full. Recommended temperature of the water is approximately 195°F.

6) In higher altitude locations (5,000 feet above sea level) the thermostat may have to be adjusted lower to
prevent boiling.

WARNING - Read and follow installation instructions before plugging or wiring in machine to electrical circuit.
Warranty will be void if unit is connected to any voltage other than that listed on the name plate.



FILL BREWER TANK WITH WATER BEFORE CONNECTION TO POWER SUPPLY

Model BL-2P

Model BA-P Model BL-3PW

COFFEE PREPARATION PROCEDURES

1) Place filter into brew basket.

2) Put the proper amount of coffee into the filter.

3) Slide the brew basket into holder.

4) Place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch ON.

NOTE: For airpots, open airpot lid, remove pump stem from airpot and place airpot opening directly under center hole
in brew basket.

5) Pour decanter of fresh water through pour-in opening at top of brewer.

6) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within
the brew basket. The coffee will drain from brew basket into the container below.

7) TURN OFF WARMER WHEN NOT IN USE. (Red light indicates warmer is ON.) Not for airpot brewers.

8) Before brewing next pot, remove brew basket from brew rails and dump filter into waste basket.

Item No. Part No. Description Item No. Part No. Description

1 73035 Water Tank 32 100524 Bracket, Hi-Limit Thermostat
2 07327 Clamp, Black 5/8” 33 73008 Nut Slotted Hex (size M20x1.50)
3 05826 Tubing, 3/8” x 5/8” Silicone 34 73010 Pan, Receiving
4 61232 Plug, 3/8” Barbed 35 73019 Access Panel
5 73057 Gasket, Tank O-Ring 36 73024 Base Cover Panel, BA-P
6 70820 Element, Heating 1400W 120V 37 73027 Airpot Stopper

70818 Element, Heating 2500W 240V 38 73028 Leg, Support
7 73037 Inlet Tube Assembly 39 73095 Bracket, Tank
11 73032A Cover, Tank w/ Bracket Thermostat 40 73000 Bracket Warmer
12 71147 Grommet, Thermostat 41 73031 Panel, Warmer Top BL-2P
13 61243 Grommet, Inlet Tube 42 73004 Top Cover SS, BL-2P
15 62238 Bracket, Hi-Limit, 120V 43 73015 Panel, Top Body, BL-2P
16 73096 Thermostat Clip Lock 44 73017 Panel, Back BL-2P
17 73036 Thermostat Regulating 45 73023 Panel, Center SS, BL-2P
20 05911-02K Brew Basket 46 73029 Panel, Base Cover BL-2P
21 73059 Switch Warmer Lighted 120V 50 73011 Panel, Spray Head Assy

73058 Switch Warmer Lighted 230V 51 73012 Rail Brew, L.H.
22 62436 Ready Light, Green (120V) 52 73013 Rail Brew, R.H.

61125 Ready Light, Green (240V) 53 73049 Plastic Jug
23 06491 Deflector, Spray HD 55 73003 Top Cover SS, BA-P
24 06490 Nozzle, SPR HD 56 73014 Panel, Top Body, BA-P
25 07220 Nut, Lock Palnut SPR HD 57 73016 Panel, Back BA-P
26 70341 Elbow, Silicone 90 deg 58 73022 Panel, Center SS, BA-P
27 71607 Panel, Pour-Over Lid 54 73021 Bracket Tank Base, BA-P
28 71529 Wire Hinge, Pour-Over Lid 56 73005 Decal, Main Front BA-P
29 73002 Plate, Warmer 73006 Decal, Main Front, BL-2P
30 13029 Heater, Warmer 120V/100W 73097 Decal, Main Front BL-3PW
31 100523 T-Stat, 1/2” Manual Reset 59 73080 Panel, Base Cover, BL-3PW

62237 T-Stat, Hi-Limit, 120V 60 73099 Panel, Top Body, BL-3PW

SPARE PARTS LIST

AMW® Pourover Brewer Manual Page 3

WATER TANK ASSEMBLY

Page 4 AMW® Pourover Brewer Manual

31

32

39