American Dynamics ADACSNETD, ADACSNETDP Specsheet

DATA SHEET

SensorNet/Manchester Distribution Panel

Features That Make a Difference:

Amplifies SensorNet or Manchester protocol signals for multi-point

dome control Switch easily between SensorNet or Manchester protocols Accommodates home-run dome wiring via 16 output ports Supports home-run, daisy chain, and junction box (J-Box) wiring

topologies to accommodate any size system Install at head end or remote locations Rack (2U) mountable Thin, single PCB design allows the panel to be mounted either at the

front or rear of an electronics rack, facing in or out Surge suppression available on all data and power connections ADACSNETDP model includes power supply for multiple panels Compatible with American Dynamics® MegaPower matrix switcher/

controller systems and Intellex

Digital Video Management Systems

The SensorNet/Manchester distribution panel amplifies either a SensorNet or Manchester protocol signal for multi-point dome control which provides the flexibility to operate efficiently in either protocol setting. With 16 output driver links (two connectors per link), the panel can accommodate home-run dome wiring, multiple daisy-chained links to domes, or J-Boxes.

The panel also includes inputs for two hosts allowing you to maintain a connection between both the primary and backup CPUs and the devices connected to the panel, thereby providing a redundant solution1. For the ultimate control, you can monitor signal activities on each channel.

Installing the panel is easy, either at the head end or at remote locations and it can be used in place of a SensorNet J-Box when power is available for domes locally. The sleek, 2U design can easily be mounted at the front or rear of an electronics rack, facing in or out.

The panel is compatible with all versions of American Dynamics SpeedDome programmable dome cameras, Manchester receiver drivers, J-Boxes, and control systems that use SensorNet or Manchester protocols.

(1) The host input ports will be used in sequence whenever the previous input port is not receiving data.

SPECIFICATIONS

Model Numbers

ADACSNETD .............. SensorNet/Manchester Distribution Panel

ADACSNETDP ............. SensorNet/Manchester Distribution Panel

(without external power module)

(with external power module)

Physical

Dimensions (L x W x D) .......481 x 87 x 34 mm (18.9 x 3.4 x 1.3 in)

Body Length ...............445 mm (17.6 in)

Weight ...................0.75 kg (1.66 lbs)

Mounting ................. Standard electrical rack (2U), EIA-310-D (19 in)

IEC 60297-1 (482.6 mm) Wall mount

Electrical

Power Source .............. External power module

Input ..................... 12 to 30 V DC or AC

Power Consumption .........8 VA

Diagnostic Indicators

Power On/Heartbeat .......Green LED

Noise Detect ..............Red LED

Host A and B Receive Data . .Yellow LED Channels 1-16 Receive Data .Yellow LED

Protection ................. Internal primary current fuse

Cable to Transformer ........ 5 m (16.5 ft)

Input Connector ............ Euro-style 3-pin removable plug

Surge Protection Transient Voltage Suppressors

(TVS) ...................60 V, 250 A, 1.5 J

Certiﬁed limited power source required Multiple panels may be connected up to the maximum VA rating of the transformer

Isolation not required NEC Class 2

Inrush limiting DC isolation

18 AWG (0.823 mm

), 3-conductor

5.06 mm (0.2 in) terminal block

Gas discharge tube

impulse rated .............10 kA

Design Tolerance

Input Voltage Minimum ......11 V DC or AC without drop out

Input Voltage Maximum. .....>36 V DC or AC

Input Frequency ...........47 to 63 Hz

Allowable Dropout .........150 ms

Surge Protection

SensorNet/Manchester Ports

Transient Voltage Suppressors (TVS)

Breakdown Voltage ........7.6 to 9.3 V DC

Peak Current .............40 A

Capacitance ..............2000 pf at 1 kHz

Gas Discharge Tube Impulse Rate

DC Breakdown Voltage .....90 V DC

Insulation Resistance .......10,000 mΩ

Capacitance ..............2 pf max

8/20 µsec Impulse Discharge

Current ..................10 kA

Ten 8/20 µsec Impulses

Discharge Current .........5 kA

Isolation Transformer

Coupled .................. 2000 Vrms

PTC re-settled fuse protects transformer

Environmental

Operating Temperature .......-10° to 50°C (14° to 122°F)

Storage Temperature ........-40° to 70°C (-40° to 158°F)

Relative Humidity ...........0 to 95% noncondensing

Regulatory

EMC ...................... 47 CFR, Part 15

EN50130-4; EN55022 EN61000-3-2; EN61000-3-3

CISPR22

Safety .................... UL/IEC/EN/CSA C22.2.60950-1

Environmental .............. RoHS 2002/95/EC

WEEE 2002/96/EC IP code X0

DATA COMMUNICATION

SensorNet Manchester

Address Range Bit Rate

Maximum Cable Segment

Maximum Loads Cable Segment Repeaters Topologies

Transmission Medium

Connector

Connector PIN Assignments

1 km (3,300 ft) if repeaters are used

1.5 km (5,000 ft) if repeaters are not used 32 devices per cable segment 3 per run

SensorNet J-Boxes, distribution panels Distribution panels

Daisy chain, backbone, or star Daisy chain

Single non-polarized unshielded twisted pair UTP

Euro-style 3-pin removable plug 3.5 mm (0.14 in)

terminal block, Shield not used

PIN 1 - S+ (orange wire) PIN 2 - S - (yellow wire)

PIN 3 - Ground (Shield not used)

Terminating Resistor Physical Layer

RS-485, transformer-isolated, 2-wire RS-485, transformer-isolated, 2-wire

Link Layer Communications

ADMPCPU, ADTT16E Primary Touch Tracker, MegaPower 48

Controller Devices

Secondary Devices

(2) Input voltage greater than 36 VDC or AC may damage equipment (3) The maximum cable segment distance shown is the total distance per ADACSNETD driver. The panel contains 16 drivers labeled 1 through 16 and each driver has two physical

connectors on the front panel. If only one of the two connectors is used, the full distance can be applied to that connector. If both of the connectors are being used, the combined distance should not exceed the amount shown based upon wiring specified above.

Product offerings and specifications are subject to change without notice. Actual products may vary from photos. Not all products include all features. Availability varies by region; contact your sales representative. Certain product names mentioned herein may be trade names and/or registered trademarks of other companies.

Plus, MegaPower LT, Intellex Digital Video Management System,

and ADACSNET SensorNet USB Module

SpeedDome Series and American Dynamics receivers/drivers,

distribution panels, J-Boxes, secondary Touch Tracker,

1 to 254 1 to 64

230.4 kbps 31 kbps

Single twisted pair 18 AWG (0.823 mm2) (Belden 8760),

22 AWG (0.326 mm2)

Euro-style 3-pin removable plug 3.5 mm (0.14 in) terminal block

PIN 1 - S+ (black wire) PIN 2 - S- (white wire)

120 Ω, switch selectable 120 Ω, switch selectable

Bi-directional, half duplex Simplex

ADMPCPU, AD2091, MegaPower 48 Plus,

SpeedDome Programmable Dome Cameras

and SensorNet I/O unit

www.americandynamics.net

1.5 km (5,000 ft)

polarized, Shielded

PIN 3 - Ground (Shield used)

and MegaPower 3200